9362705b, Operating Manual UFD 170 DVB-S Receiver ... - Kathrein

Installation Menu
22 kHz Signal
You should only make changes in this menu if the receiver is connected
to a different receiving system with different properties or if changes
have been made to the receiving system.
You should therefore carefully follow the instructions for your satellite
system. However, before each change you should note the settings on
the form at the end of this operating manual.
You reach the “DiSEqC[UFO] Setup” menu using the
keys and the key in the Installation menu.
This menu option is used to specify whether the 22 kHz signal is to be
used to switch between the upper and lower frequency ranges for a
satellite (low/high) or between two satellite positions.
Tone Burst and DiSEqC TM Signal
If more than four control criteria are requried in a receiving system, a
DiSEqC control signal is required.
Switching states for setting:
22 kHz Signal -----------> High/Low
and
Tone Burst -----------> Pos. A/B:
DiSEqC TM
Low 22 kHz Off
High 22 kHz On
Pos. 1 Tone Burst 0
Pos. 2 Tone Burst 1
DiSEqC TM Repeat
Which of the setting options - Tone Burst or DiSEqC - is required
depends on the components of the receiving system.
You should therefore refer to the descriptions of the existing
components (switching matrices) of the receiving system.
Switching states for setting:
22 kHz Signal -----------> Pos. A/B:
and
Tone Burst -----------> Opt. A/B:
Pos Tone Burst 22 kHz
1 0 Off
2 0 On
3 1 Off
4 1 On
Switching states for setting:
22 kHz Signal -----------> Pos. A/B:
and
Tone Burst -----------> High/Low
Low Tone Burst 0
High Tone Burst 1
Pos. 1 22 kHz Off
Pos. 2 22 kHz On
If the receiver is connected to a DiSEqC switching matrix, set the
menu option to “On”.
The switching criteria and the input assignment of the DiSEqC
switching matrices must be observed. You should therefore follow
the description of the switching matrices or contact the engineer
who installed the receiving system.
If the receiver is operated in a receiving system with two or more
DiSEqC switching matrices connected in series (cascaded), the
DiSEqC command must be repeated.
In this case, set the DiSEqC Repeat menu option to “1” or “2”.
Default setting: “Off”
57