mitac w130.pdf - tim.id.au

More documents

Recommendations

Info

9-8 Memory Test Error The extend SO-DIMM SDRAM is failure or system hangs up. Memory Test Error 1. Check if the expansion SO-DIMM module is installation properly. 2. Make sure that SO-DIMM sockets are good. 3. Try another known good SO-DIMM modules. Test ok ? If your system host bus clock running at 100MHZ then make sure that DIMM module meet require of PC 100. Test ok? No No Yes Yes Replace Motherboard Board-level Troubleshooting Check if U533, J504 are cold Solder? No Yes Replace the faulty SO-DIMM module Replace the faulty SO-DIMM module. Re-soldering 68 Check the following parts: Parts: Signal:
9-9 Keyboard and Touch –pad Test Error Error message of keyboard or touch-pad is failure or any keys does not working properly. Keyboard or touch-pad test Is K/B or T/P cable connected to Notebook properly? Yes Yes No Try another known good keyboard or Touch-pad Test OK? No Replace motherboard Board-level Troubleshooting Check if U533, J504 are cold Solder? No Yes Connect it. Replace the faulty keyboard or Touch-pad Re-soldering 69 Check the following parts: Parts: Signal:
Page 2 and 3:
1 General system Description ......
Page 4 and 5:
9-9 Hard Drive Test Error .........
Page 6 and 7:
A full set of software drivers and
Page 8 and 9:
MS-Sound compatible Built-in one sp
Page 10 and 11:
Support I2C Index read/write and bl
Page 12 and 13:
images and native display timings o
Page 14 and 15:
Destination Alpha Vertex Cahec Ma
Page 16 and 17:
WfM 2.0 and IEEE 802.3 compliant L
Page 18 and 19: conditions from ramp-up through ful
Page 20 and 21: Supports double sampling rate (96KH
Page 22 and 23: 2.3 Cover Switch System automatical
Page 24 and 25: One USB 2.0 Port Supports UHCI Desi
Page 26 and 27: 3.1 LCD PANEL 3 Peripheral Support
Page 28 and 29: 4 Power Management The Tetra system
Page 30 and 31: 5 Connector and Switch Definition T
Page 32 and 33: CAD19 56 CardBus address/data bus C
Page 34 and 35: Table 5-7 MDC TRANSFER BD Connector
Page 36 and 37: FPC_PWR# 62 Floppy POWER FDD_CTL# 6
Page 38 and 39: 6-1 Front View Wireless Antenna 6-2
Page 40 and 41: 6-5 Rear View USB Port 6-6 Top-open
Page 42 and 43: 6-9 Docking Module Right-Side View
Page 44 and 45: 7-2 Bottom Housing Disassembly Step
Page 46 and 47: 7-4 Memory Disassembly Step: 1. Rem
Page 48 and 49: 7-6 Keyboard Disassembly Step: 1. R
Page 50 and 51: 7-7 LCD Panel Disassembly Step: 1.
Page 52 and 53: Reassemble Step: Step 2 Step 3 1. C
Page 54 and 55: 7-10 Docking Mother Board Disassemb
Page 56 and 57: J13 J14 8 Location of Connectors /
Page 58 and 59: 8-3 D/D Board-A J500 JS500: Power
Page 60 and 61: 8-6 Docking Main Board-B J2 J2: Do
Page 63 and 64: 9-3 No Power When the power button
Page 65 and 66: 9-5 No display There is no display
Page 67: 9-7 External Monitor No Display or
Page 71 and 72: 9-11 Hard Drive Test Error Either a
Page 73 and 74: 9-13 System Audio Failure No sound
Page 75: 10 System Exploded views & Circuit
show all

mitac w130.pdf - tim.id.au

Create successful ePaper yourself

Delete template?

Save as template?