Download Manual - Janome
Download Manual - Janome
Download Manual - Janome
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
x<br />
x<br />
z<br />
n m<br />
v b<br />
c<br />
11<br />
• Winding the bobbin<br />
z Draw the thread from the spool.<br />
x Guide the thread around the thread guide.<br />
c Thread through the hole in the bobbin from the inside<br />
to the outside.<br />
v Put the bobbin on the bobbin winder spindle.<br />
b Push the bobbin to the right.<br />
The indicator window will show sign.<br />
n With the free end of the thread held in your hand,<br />
depress the foot control. Stop the machine when it<br />
has wound a few layers, and then cut the thread<br />
close to the hole in the bobbin.<br />
m Depress the foot control again. When the bobbin is<br />
fully wound, it stops automatically. Return the bobbin<br />
winder to its original position by moving the spindle to<br />
the left, and cut the thread as shown.<br />
NOTE:<br />
The machine will not sew until the spindle has been<br />
returned to the left.<br />
NOTE:<br />
Make sure that the carrying handle is not being raised<br />
when winding the bobbin.<br />
NOTE:<br />
The machine motor automatically stops after 2 minutes<br />
if you do not stop the machine.