SAP Printing Customer documentation Volume 2 : [ZA0x] The ... - ELP

SAP Printing: Customer documentation: Volume 2: [ZA0x] page 45 / 59
Most likely you need only modify the "Printer initialization" action of some of the Formats; see the section "How to edit a Device format" below.
It is very unlikely that you would also need to edit or even add a Print control; for this see the sections "How to create/edit a Print control" below.
5.1.5 How to delete an entire Device type definition
If a device type is no longer needed, you may wish to delete the entire definition.
1. Run transaction SE38 (ABAP Editor).
2. Run report RSTXDPRI.
3. Specify name of the device type to delete
4. [X] Delete
Alternatively, you can delete the device type from SPAD. However, prior to this you first need to manually delete all its Formats and Print
controls, and for all Output devices in which it is used the Device type entry needs to be changed.
5.1.6 How to create a Print control
To add a new Print Control, the following steps have to be taken:
1. Add a new Print control to the set of "Standard Print controls".
1. Run transaction SPAD -> "Full administration" -> "Device types" -> "Print Controls".
2. Enter "Change" mode.
3. Menu : "Standard PrCtrl" : "Create (using template)"
4. Specify:
- The name (it should start with the letter "Y" or "Z")
- A descriptive comment
- Some additional parameters
5. Save.