Resi-Toner Tone Generator User's Guide - JDSU

More documents

Recommendations

Info

Hint: The currently selected tone type is generated at the RJ jack once the signal selection function is entered. Holding a tone tracer near the jack will allow the user to hear each tone type as it is selected. 13
Battery Replacement 1) 2) 3) 4) Remove lower screw on the rear of the Resi-Toner with a #1 Phillips screwdriver and remove door. Remove old battery and disconnect from battery leads. Snap the battery leads onto a new battery (9V, alkaline). Place battery in case. Close tester and replace screw. Do not over tighten. 14
Page 1: Resi-Tonerf Tone Generator User's G
Page 4 and 5: WARNING! Do not attach to AC power.
Page 6 and 7: Note: The RJ jumper “no-fault”
Page 8 and 9: 3) 4) 5) position. Press ON/OFF to
Page 10 and 11: To Supply Talk Battery Power 1) 2)
Page 12 and 13: To Pop Speaker 1) 2) 3) 4) Connect
Page 14 and 15: y reducing the field canceling effe
Page 18 and 19: Models, Options & Accessories Order
Page 20 and 21: Customer Services This section prov
Page 22 and 23: problem or service requested. • T
Page 24 and 25: is reused, recycled, or disposed of
Page 26: Notes: 23

Resi-Toner Tone Generator User's Guide - JDSU

Create successful ePaper yourself

Delete template?

Save as template?