BWC455BGL Built-in wine cabinet - Baumatic

More documents

Recommendations

Info

Reversing the door handle 1) Remove the gasket on the right inner side of the door to expose the 2 decorative screws. Unscrew them in a clockwise direction with a flat blade screwdriver and then loosen them in an anticlockwise direction, using your fingers, from the outer side of the door. The screw holes will then be ready for installing the handle on the right hand side. 2) Remove the gasket on the left inner side of the door to expose the 2 handle screws. Unscrew them in an anti-clockwise direction with a cross head screwdriver. Remove the screws and washers as well as the handle. 3) Install the handle onto the outer right side of the door. 26
4) Install the 2 decorative screws into the holes at the left side of the outer door. 27
Page 1 and 2: BWC455BGL Built-in wine cabinet
Page 3 and 4: Contents Environmental note 4 Impor
Page 5 and 6: Important safety information Use of
Page 7 and 8: Service You should not attempt to r
Page 9 and 10: Control panel The control panel is
Page 11 and 12: During first use IMPORTANT: When yo
Page 13 and 14: Loading the wine cabinet o IMPORTAN
Page 15 and 16: Wine storage problems Corking- a ti
Page 17 and 18: o You should be careful to make sur
Page 19 and 20: o When the connection is completed,
Page 21 and 22: Installing the handle o To secure t
Page 23 and 24: 4) Pull the harness wires one by on
Page 25: IMPORTANT: Check that the door open
Page 29 and 30: spare periodical running can not en
Page 31 and 32: Technical Data Manufacturer BAUMATI

BWC455BGL Built-in wine cabinet - Baumatic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?