 Apple Technician Guide MacBook Pro (17-inch, Mid ... - tim.id.au

More documents

Recommendations

Info

First Steps Remove: • Bottom case Before you begin this procedure, disconnect the battery from the logic board. Failure to do so could damage the computer. 2010-06-11 Fans MacBook Pro (17-inch, Mid 2010) Take Apart — Fans 142
Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat • Torx T6 screwdriver • Black stick Removal 1 Disconnect each fan cable. 2 Remove 6 (3.3-mm) 922-9108 screws. 3 Remove fan(s) from top case. Replacement Note: To identify the fans for ordering parts, • right fan is closest to optical drive • left fan is closest to LVDS connector Replacement Note: Prevent cable pinching at right fan by installing screws first. Then route right fan cable between screws and reapply tape. If tape is damaged, use Kapton tape instead. 2010-06-11 MacBook Pro (17-inch, Mid 2010) Take Apart — Fans 143
Page 1 and 2:
apple Apple Technician Guide MacBoo
Page 3 and 4:
MacBook Pro (17-inch, Mid 2010) Con
Page 5 and 6:
Built-in Keyboard Does Not Work Pro
Page 7 and 8:
Top Case 209 Views Exploded View 21
Page 9 and 10:
apple Apple Technician Guide Basics
Page 11 and 12:
2010-06-11 Note About Images in Thi
Page 13 and 14:
2010-06-11 Transferring the Serial
Page 15 and 16:
2010-06-11 The Glass Panel Warning:
Page 17 and 18:
2010-06-11 General Troubleshooting
Page 19 and 20:
2010-06-11 Functional Overview Refe
Page 21 and 22:
2010-06-11 Liquid Contact Indicator
Page 23 and 24:
2010-06-11 Display Issue: Pixel Ano
Page 25 and 26:
2010-06-11 2. Reset SMC (remove all
Page 27 and 28:
2010-06-11 Won’t Start Up Unlikel
Page 29 and 30:
2010-06-11 8. Use Disk Utility load
Page 31 and 32:
2010-06-11 Suggested steps for trou
Page 33 and 34:
2010-06-11 6. Check with known-good
Page 35 and 36:
2010-06-11 3. Adjust Brightness Pow
Page 37 and 38:
2010-06-11 Battery Isn’t Recogniz
Page 39 and 40:
2010-06-11 13. Open Apple System Pr
Page 41 and 42:
2010-06-11 4. Remove I/O device whe
Page 43 and 44:
2010-06-11 Battery Run Time Too Sho
Page 45 and 46:
2010-06-11 Deep Dive Check Result A
Page 47 and 48:
2010-06-11 5. Verify if the noise i
Page 49 and 50:
2010-06-11 Battery Leaking or Swoll
Page 51 and 52:
2010-06-11 3. Verify if IP address
Page 53 and 54:
Page 55 and 56:
2010-06-11 No/Poor Wireless Signal
Page 57 and 58:
2010-06-11 Bluetooth Wireless Input
Page 59 and 60:
2010-06-11 AirPort Card: Kernel Pan
Page 61 and 62:
2010-06-11 2. Turn off Bluetooth. R
Page 63 and 64:
2010-06-11 5. Verify if Bluetooth a
Page 65 and 66:
2010-06-11 Deep Dive: Incorrect/Mis
Page 67 and 68:
2010-06-11 Deep Dive: Vertical/Hori
Page 69 and 70:
2010-06-11 2. Run Clamshell Service
Page 71 and 72:
2010-06-11 6. Substitute with a kno
Page 73 and 74:
2010-06-11 Noise / Unstable Flicker
Page 75 and 76:
2010-06-11 Mass Storage Hard Drive
Page 77 and 78:
Page 79 and 80:
2010-06-11 5. After installing new
Page 81 and 82:
2010-06-11 7. Verify if optical med
Page 83 and 84:
Page 85 and 86:
2010-06-11 7. Disc spin should ceas
Page 87 and 88:
2010-06-11 Input/Output Devices USB
Page 89 and 90:
2010-06-11 4. Reseat cable and chec
Page 91 and 92: 2010-06-11 7. Verify if a known-goo
Page 93 and 94: 2010-06-11 Built-in Keyboard Is Not
Page 95 and 96: 2010-06-11 Apple Remote Inoperable
Page 97 and 98: 2010-06-11 Built-in Speaker Has No
Page 99 and 100: 2010-06-11 4. Verify if affected sp
Page 101 and 102: 2010-06-11 Deep Dive Check Result A
Page 103 and 104: 2010-06-11 Camera Issues Unlikely c
Page 105 and 106: 2010-06-11 Mechanical Issues: Therm
Page 107 and 108: 2010-06-11 System Runs Hot Unlikely
Page 109 and 110: 2010-06-11 Uncategorized Symptom Qu
Page 111 and 112: Vertical Insertion (JST) • Use bl
Page 113 and 114: Note: Removing the mesh ground tab
Page 115 and 116: 2010-06-11 Icon Legend The followin
Page 117 and 118: Removal Caution: To prevent scratch
Page 119 and 120: 4 Warning: If performing any other
Page 121 and 122: First Steps Remove: • Bottom case
Page 123 and 124: 3 Peel up battery label, and discar
Page 125 and 126: 4 Using black stick or pull-tab, co
Page 127 and 128: Tools • Clean, soft, lint-free cl
Page 131 and 132: Replacement 1 Make sure rubber grom
Page 135 and 136: Replacement 1 Install cards at an a
Page 141: 4 Remove 2 (7.1-mm) 922-8645 screws
Page 149 and 150: 7 Caution: The optical drive is ver
Page 161 and 162: Replacement 1 Place the display on
Page 163 and 164: Replacement Caution: To prevent no
Page 165 and 166: Removal 1 Cover display face with c
Page 167 and 168: 3 Check that cable routing at end o
Page 171 and 172: 4 Lift out holder and turn it over.
Page 177 and 178: 3 Loosen from adhesive at side and
Page 181 and 182: 4 Remove 6 (3.3-mm) 922-9108 screws
Page 183 and 184: If replacing the logic board with a
Page 185 and 186: Removal 1 Remove 6 #000 (1.3mm) Phi
Page 187 and 188: 9 Tilt up top case, and spiral trac
Page 189 and 190: 3 Slide stiffeners over the flexure
Page 191 and 192: 9 Fold sticky notes over so that to
Page 193 and 194:
First Steps Remove: • Bottom case
Page 195 and 196:
Replacement Caution: Plug in a disc
Page 197 and 198:
Tools • Clean, soft, lint-free cl
Page 199 and 200:
Replacement Important: New heatsink
Page 201 and 202:
Page 203 and 204:
2 Remove 2 (8-mm) 922-8720 screws.
Page 205 and 206:
Removal Note: Do not touch the soft
Page 207 and 208:
Tools • Clean, soft, lint-free cl
Page 209 and 210:
Page 211 and 212:
Replacement Note: Before assembling
Page 213 and 214:
2010-06-11 Display Clutch Cover 922
Page 215 and 216:
2010-06-11 Right Speaker/Subwoofer
Page 217 and 218:
2010-06-11 Port View A = MagSafe po
Page 219 and 220:
2010-03-02 Screw Locations Bottom C
Page 221 and 222:
2010-03-02 Optical Drive, AirPort/B
Page 223 and 224:
2010-03-02 Battery Indicator Light
Page 225 and 226:
2010-03-02 Cable Guides from Displa
Page 227 and 228:
2010-03-02 Front Hard Drive Bracket
show all

 Apple Technician Guide MacBook Pro (17-inch, Mid ... - tim.id.au

Create successful ePaper yourself

Delete template?

Save as template?