Blaster – 3 Assembly Manual Contents 1. Parts and Materials list ...

ePAPER READ

DOWNLOAD ePAPER

fvk.de

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

START NOW

3) Glue servos with CA, but leave the battery mounted with tape.

Install radio gear 1) Cut the lugs off your servos, Hyperion DS09-AMD/DS11-AMD or Futaba S3156MG, and cover them with masking tape. Optionally, wind thin but strong thread (e.g., Kevlar) around them. 2) If you opt for a non-movable rudder, place servos as shown in this picture. If you would like to control the rudder too, place the rudder servo behind the battery and mount everything temporarily with tape. Make sure that nose cone clears the servo arms!!! 6

3) Glue servos with CA, but leave the battery mounted with tape. 7

Page 1 and 2: Blaster - 3 Assembly Manual Content
Page 3 and 4: 14) Aileron pushrods 15) Rudder & e
Page 9 and 10: Install aileron pushrods 1) Mount t
Page 11 and 12: 4) Install the vertical stabilizer
Page 13 and 14: 3) Slide heat shrink tube over the
Page 16: Setup the plane We recommend progra

Blaster – 3 Assembly Manual Contents 1. Parts and Materials list ...

Create successful ePaper yourself

Delete template?

Save as template?