BUILDINGS – SoR: 2012-2013

Sl.
No
44
Building Items (Civil) – Buildings SoR: 2012-13
Item Code Description of item Unit
SS RATE
FOR
20012-13
1 2 3 4 5
634 BMT-M.76 Supply and fixing of BISONLAM wall paneling using 12MM
BISONLAM with frame work made of G.I stud section of size 48mm
x 35mm x 0.55mm thick placed at every 610mm intervals vertically
and at 1200mm internals horizontally fixed to the wall by means of
self expansion screws and caps. BISON LAM is to be fixed to frame
by means of self-taping screws placed at every 300mm intervals
leaving 3mm gap between two panels. The cost inclusive of
Conveyance of materials, Labor charges etc., complete as per the
direction of Engineer in charge
1 Sqm 1725.00
635 BMT-M.77 Supply and fixing of BISON LAM aluminum glazed partitions using
10MM BISONLAM and 5.50 mm thick plain glass to full height.
Using with BISON LAM to a height of 0.91 meter at bottom panel
and remaining height with glass and aluminum sections anodized
to 12 to 15 microns and of sections of size 37mm x 62mm and
1.5mm thickness with one meter centre to centre duly fixed with
clip beading on both sides including fixing the frame to pillars by
M.S. flats, bolts and nuts including cost and conveyance of all
materials etc., complete as directed during execution.
1 Sqm 2888.00
636 BMT-M.78 Providing and fixing 50mm thick “RAJSHRI” or equivalent SEMI
HEIGHT SOLID PVC PARTITION consisting of 49mm sandwich PVC
panel made out of 36mm high density expanded polystyrene
sheet(E.P.S.-Thermocole) stuck on both side with 2mm thick
plain/printed /prelam PVC rigid foam sheets reinforced with frame
work made from 35mmX5mm M.S. Angle. In between two M.S.
Angles 5mm thick plain/printed/prelam heat moulded “Rajshri”
PVC ‘C’ channel of size 50X100mm with feathered edges shall be
fixed on the floor & 50X75mm with feathered edges plain/printed
/prelam PVC ‘C’ channel. In between adjoining EPS sandwiched
1 sqm 2700.00
PVC partitions panel 5mm thickX75mm width
plain/printed/prelam PVC sheet feathered at edges shall be stuck
on front & back face using solvent cement etc. in places where two
partitions meet to from an ‘L’ shape the panels are joined 5mm
thick plain/printed/prelam heat moulded “Rajshri” PVC ‘L’ section
of size 75mmX75mm with feathered edges shall be fixed on front
& back side. This is done to maintain the symmetry of design. An
additional 5mm thick PVC strip of 40mm width is to be stuck on
the interior side of the ‘C’ Channel using PVC solvent adhesive,
complete as per direction of Engineer-in-Charge, manufacture’s
specification & drawing