Steam or HTHW to Steam Humidifier SKS Series - Humidity Solutions

More documents

Recommendations

Info

! Water Drain Specification Water Drain Installation SKS - Steam or HTHW to Steam Humidifier Stage 5 – Water Drain Connection Water Drain installation should conform to local codes and regulations. Any installation work must be carried out by suitably qualified personnel. Water Drain temperature: +60˚C Model 20 Water Drain Outlet Connection size SKS-200/333/667-CHP Ø22mm Water drain outlet connection should be connected to drain pipe of sufficient size. We recommend the use of Ø22mm minimum standard copper hydraulic pipes. Water main drain and drip pan must be kept separate to the open drain. Do not connect the main drain and the drip pan before the open drain. Minimum water drain pipe gradient should be 1.5mm in 1m horizontal run. No drain trap is required on the main drain. SKS (Fig. 17) Ø 22mm (¾’’) Building water drain Ø 28mm minimum
Electrical Power Supply ! Electrical connection SKS - Steam or HTHW to Steam Humidifier Stage 6 –Electrical Supply and Installation The SKS Humidifier requires the following single phase supply. Model Voltage Current SKS-200/333/667-CHP 230Vac – 1ph 0.75A All incoming power supplies MUST be externally fused for over current protection. The electrical supply should also be isolated for the purpose of emergency and servicing. Disconnect switch should be installed typically within one meter of the humidifier. The isolator must have a contact separation of at least 3mm. All work concerned with electrical installation MUST only be performed by skilled and qualified technical personnel (e.g. electrician or technicians with appropriate training). Please observe local codes and regulations concerning the provision of electrical installations. WARNING. Risk of electric Shock. Ensure that the electrical supply is isolated before commencing any installation. The installation engineer must ensure the following: Use of copper power conductor only. Size of the power conductors are suitable for the maximum current supplied. Incoming power cable is secured via suitably sized cable gland. Each terminal connection is secured firmly with a cable ferrule. Humidifier cabinet has an uninterrupted or unbroken electrical ground. Do not use HTHW piping as an electrical ground. Power supply terminal block L N L N (Fig. 18) 21 GND
Page 1: Steam or HTHW to Steam Humidifier S
Page 4 and 5: SKS - Steam or HTHW to Steam Humidi
Page 6 and 7: CE directives applied Standard to w
Page 8 and 9: Output Steam Capacities For HTHW Su
Page 10 and 11: A 30.5 B (Fig. 1) dimensions are in
Page 12 and 13: ! Installation method statement Cle
Page 18 and 19: ! Union dimensions & installation S
Page 20 and 21: SKS 12'’ [30cm] minimum Raw steam
Page 24 and 25: Fundamentals about controls placeme
Page 26 and 27: Dry Contacts Two series of volt fre
Page 28 and 29: ! Clearance Electrical supply Water
Page 30 and 31: Control Panel Description ! Access
Page 38: 1. General Unless otherwise arrang

Steam or HTHW to Steam Humidifier SKS Series - Humidity Solutions

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?