High Voltage Control Unit Typ HST 01/01 - SCHNIER Elektrostatik ...
High Voltage Control Unit Typ HST 01/01 - SCHNIER Elektrostatik ...
High Voltage Control Unit Typ HST 01/01 - SCHNIER Elektrostatik ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Operating Manual<br />
1.0 General Information<br />
1.1 Introduction<br />
1.2 Scope of Application<br />
This Operating Manual (in the following called OM) has to be read,<br />
fully understood and observed in all respects by all persons who<br />
are responsible for the devices and the electrostatic installation.<br />
For these reasons the OM should always be available to the<br />
operating, maintenance and service personal.<br />
Only with the knowledge of this OM faults can be avoided and a<br />
trouble-free operation be guarenteed. Therefore it is important<br />
that the OM is known to all persons involved. The company<br />
<strong>SCHNIER</strong> <strong>Elektrostatik</strong> GmbH will not assume any responsibility<br />
resulting from the failure to comply with the OM!<br />
The HV control unit may only be used in electrostatic coating<br />
installations within the temperature range of 10°C to 40°C and a<br />
relative humidity of between 35% to 80%. Furthermore the relevant<br />
safety notes according to points 2.3 and 2.4 of this OM<br />
must be strictly observed.<br />
The HV control unit HS <strong>01</strong>/<strong>01</strong> has to be only operated with the<br />
high voltage generators of the medium frequency types supplied.<br />
by the company <strong>SCHNIER</strong> <strong>Elektrostatik</strong> GmbH.<br />
Nr. 81<strong>01</strong>23BE_02/00<br />
Page 3 of 17
Change language