LON ? Network 3065 - SimonsVoss technologies

Page 4
2.2 Programming
Digital Locking System 3060
You will need the SmartCD and a PDA for programming the digital
components. The data is encoded and then transmitted to the digital
components via radio signal.
2.3 Digital Locking Cylinder 3061
Another possibility for programming a Digital Locking Cylinder 3061 and
Transponder 3064 is with the Programming Transponder 3067. For
example, you can issue or change access authorizations in small
systems by simply pressing a button when you lose a key or change the
locking plan. No PC or special system software is needed.
The Digital Locking Cylinder 3061 is a compact, powerful
access control system that can be installed in any door in
only minutes. Its dimensions correspond to those of an
ordinary mechanical cylinder that meets the norms.
Because the Digital Locking Cylinder 3061 has batteries
(master and backup batteries), it can be installed without
wires in all Euro Profile doors and can replace already
existing
mechanical cylinders. A drop in the battery voltage is indicated by a multilevel
warning system (service life approximately 60,000 operations).
2.4 Digital Smart Relay 3063
2.5 Transponder 3064
The SimonsVoss Smart Relay is an electronic switch that can be
switched with a SimonsVoss transponder. You can use the
SimonsVoss software to configure the authorisation for transponders
that are permitted to operate the Smart Relay. In this way, the Smart
Relay offers the full function of an access control reader.
The Transponder 3064 is a digital key that can be programmed
using SimonsVoss software and that works by radio transmission,
without contact. It not only replaces mechanical keys, but also takes
over the function of identity cards. Simply pressing a button triggers
the encoded communication between the transponder and locking