Installation Guide - SMC

Application Notes
APPLICATION NOTES
1. Full-duplex operation only applies to point-to-point access (such as
when a switch is attached to a workstation, server or another switch).
When the switch is connected to a hub, both devices must operate in
half-duplex mode.
2. To interconnect distinct VLANs or IP subnets, you can attach the
switch to a standard Layer 3 router. For network applications that
require routing between dissimilar network types, you can attach the
switch directly to a router.
3. As a general rule the length of fiber optic cable for a single switched
link should not exceed:
• 1000BASE-SX: 550 m (1805 ft) for multimode fiber.
• 1000BASE-LX: 5 km (3.2 miles) for single-mode fiber.
• 1000BASE-ZX: 70 km (43 miles) for single-mode fiber.
However, power budget constraints must also be considered when
calculating the maximum cable length for your specific environment.
2-5