Installation Guide - SMC

More documents

Recommendations

Info

COMPLIANCES viii network until the problem has been corrected or until you are sure that the equipment is not malfunctioning. This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tariffs. Industry Canada - Class A This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus,” ICES-003 of the Department of Communications. Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils numériques de Classe A prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques,” NMB-003 édictée par le ministère des Communications. CE Mark Declaration of Conformance for EMI and Safety (EEC) <strong>SMC</strong> contact for these products in Europe is: <strong>SMC</strong> Networks Europe, Edificio Conata II, Calle Fructuós Gelabert 6-8, 2o , 4a , 08970 - Sant Joan Despí, Barcelona, Spain. This information technology equipment complies with the requirements of the Council Directive 89/336/EEC on the Approximation of the laws of the Member States relating to Electromagnetic Compatibility and 73/23/EEC for electrical equipment used within certain voltage limits and the Amendment Directive 93/68/EEC. For the evaluation of the compliance with these Directives, the following standards were applied: RFI Emission: • Limit class A according to EN 55022:1998 • Limit class A for harmonic current emission according to EN 61000-3-2/1995 • Limitation of voltage fluctuation and flicker in low-voltage supply system according to EN 61000-3-3/1995 Immunity: • Product family standard according to EN 55024:1998 • Electrostatic Discharge according to EN 61000-4-2:1995 (Contact Discharge: ±4 kV, Air Discharge: ±8 kV) • Radio-frequency electromagnetic field according to EN 61000-4-3:1996 (80 - 1000 MHz with 1 kHz AM 80% Modulation: 3 V/m) • Electrical fast transient/burst according to EN 61000-4-4:1995 (AC/ DC power supply: ±1 kV, Data/Signal lines: ±0.5 kV)
COMPLIANCES • Surge immunity test according to EN 61000-4-5:1995 (AC/DC Line to Line: ±1 kV, AC/DC Line to Earth: ±2 kV) • Immunity to conducted disturbances, Induced by radio-frequency fields: EN 61000-4-6:1996 (0.15 - 80 MHz with 1 kHz AM 80% Modulation: 3 V/m) • Power frequency magnetic field immunity test according to EN 61000-4-8:1993 (1 A/m at frequency 50 Hz) • Voltage dips, short interruptions and voltage variations immunity test according to EN 61000-4-11:1994 (>95% Reduction @10 ms, 30% Reduction @500 ms, >95% Reduction @5000 ms) LVD: • EN 60950-1:2001 Warning: Do not plug a phone jack connector in the RJ-45 port. This may damage this device. Attention: Les raccordeurs ne sont pas utilisés pour le système téléphonique! Safety Compliance Warning: Fiber Optic Port Safety CLASS I LASER DEVICE Avertissment: Ports pour fibres optiques - sécurité sur le plan optique DISPOSITIF LASER DE CLASSE I Warnhinweis: Faseroptikanschlüsse - Optische Sicherheit LASERGERÄT DER KLASSE I PSE Alarm When using a fiber optic port, never look at the transmit laser while it is powered on. Also, never look directly at the fiber TX port and fiber cable ends when they are powered on. Ne regardez jamais le laser tant qu’il est sous tension. Ne regardez jamais directement le port TX (Transmission) à fibres optiques et les embouts de câbles à fibres optiques tant qu’ils sont sous tension. Niemals ein Übertragungslaser betrachten, während dieses eingeschaltet ist. Niemals direkt auf den Faser-TX-Anschluß und auf die Faserkabelenden schauen, während diese eingeschaltet sind. 本製品に同梱いたしております電源コードセットは、本製品専用です。本電源コードセットは、本製品以外の製品並びに他の用途でご使用いただくことは出来ません。製品本体に同梱された電源コードセットを利用し、他製品の電源コードセットを使用しないで下さい。 ix
Page 1: TigerAccess EE 6-Band VDSL2 Switch
Page 4 and 5: Information furnished by SMC Networ
Page 6 and 7: vi WARRANTIES EXCLUSIVE: IF AN SMC
Page 10 and 11: COMPLIANCES x Power Cord Safety Ple
Page 12 and 13: COMPLIANCES xii France et Pérou un
Page 14 and 15: COMPLIANCES xiv Environmental State
Page 16 and 17: TABLE OF CONTENTS xvi Installing an
Page 18 and 19: xviii TABLES Table 1-1 Optional SFP
Page 20 and 21: FIGURES xx
Page 22 and 23: ABOUT THE TIGERACCESS EE SWITCH 1-2
Page 28 and 29: ABOUT THE TIGERACCESS EE SWITCH Con
Page 30 and 31: ABOUT THE TIGERACCESS EE SWITCH Pow
Page 34 and 35: NETWORK PLANNING 2-2 This VDSL swit
Page 36 and 37: NETWORK PLANNING 2-4 can be used fo
Page 38 and 39: NETWORK PLANNING 2-6
Page 40 and 41: INSTALLING THE SWITCH Installing Ad
Page 42 and 43: INSTALLING THE SWITCH 3-4 • Prote
Page 44 and 45: INSTALLING THE SWITCH 3-6 To rack-m
Page 46 and 47: INSTALLING THE SWITCH Installing an
Page 48 and 49: INSTALLING THE SWITCH 3-10 and with
Page 50 and 51: INSTALLING THE SWITCH 3-12
Page 52 and 53: MAKING NETWORK CONNECTIONS 4-2 each
Page 54 and 55: MAKING NETWORK CONNECTIONS Connecti
Page 56 and 57: MAKING NETWORK CONNECTIONS Connecti
Page 58 and 59:
MAKING NETWORK CONNECTIONS 1000BASE
Page 60 and 61:
MAKING NETWORK CONNECTIONS Cable La
Page 62 and 63:
TROUBLESHOOTING A-2 Ethernet port L
Page 64 and 65:
TROUBLESHOOTING A-4 Note: The switc
Page 66 and 67:
CABLES 10BASE-T/100BASE-TX Pin Assi
Page 68 and 69:
CABLES Crossover Wiring B-4 If the
Page 70 and 71:
CABLES 1000BASE-T Cable Requirement
Page 72 and 73:
CABLES RJ-21 Port Pin Assignments B
Page 74 and 75:
CABLES Console Port to 9-Pin DTE Po
Page 76 and 77:
PHYSICAL CHARACTERISTICS C-2 Buffer
Page 78 and 79:
STANDARDS Standards C-4 Ethernet St
Page 80 and 81:
COMPLIANCES C-6
Page 82 and 83:
ORDERING INFORMATION D-2
Page 84 and 85:
GLOSSARY Bandwidth The difference b
Page 86 and 87:
GLOSSARY IEEE 802.3x Defines Ethern
Page 88 and 89:
GLOSSARY TIA Glossary-6 Telecommuni
Page 90 and 91:
GLOSSARY Glossary-8
Page 92 and 93:
INDEX H hardware components 1-5 har
Page 94:
INDEX Index-4
show all

Installation Guide - SMC

Create successful ePaper yourself

Delete template?

Save as template?