Installation Guide - SMC
Installation Guide - SMC
Installation Guide - SMC
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MOUNTING<br />
3. If installing a single switch only, turn to Connecting to a Power Source<br />
on page 3-7.<br />
4. If installing multiple switches, mount them in the rack, one below the<br />
other, in any order.<br />
Desktop or Shelf Mounting<br />
1. Attach the four adhesive feet to the bottom of the first switch.<br />
ESD PORT<br />
<strong>SMC</strong>7816M/ VSW<br />
TigerAccess EE Switch<br />
TM<br />
POTS<br />
17 O 18<br />
E<br />
Mgmt O E<br />
Line<br />
Power<br />
Fault<br />
Diag<br />
Mgmt<br />
100-240V 50-60Hz 1A<br />
Figure 3-6 Attaching the Adhesive Feet<br />
2. Set the device on a flat surface near an AC power source, making sure<br />
there are at least four inches of space on all sides for proper air flow.<br />
3. If installing a single switch only, go to Connecting to a Power Source at<br />
the end of this chapter.<br />
4. If installing multiple switches, attach four adhesive feet to each one.<br />
Place each device squarely on top of the one below, in any order.<br />
E<br />
17<br />
O<br />
E<br />
18<br />
O<br />
1 5 9 13<br />
2 6 10 14<br />
3 7 11 15<br />
4 8 12 16<br />
Console<br />
3-7
Change language