Burner System Management
Burner System Management
Burner System Management
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
The keys functions are the following:<br />
The display will show these data:<br />
Key F<br />
Used to adjust the “fuel” actuator position (Fuel): :<br />
While pressing the F key, the “fuel” actuator position can be changed by means of the + and - keys.<br />
Key A<br />
Used to adjust the “air” actuator position (Air):<br />
While pressing the A key, the “air” actuator position can be changed by means of the + and - keys.<br />
Key F + A<br />
While pressing the two keys contemporarly, the code message will appear: by entering the proper<br />
password it is possible to access the Service mode.<br />
Info and Enter keys<br />
Used for Info and Service menues<br />
Used as Enter key in the setting modes<br />
Used as Reset key in the burner operation mode<br />
Used to enter a lower level menu<br />
-Key -<br />
Used to decrease a a value<br />
Used to enter Info and Serivce during the curve adjustments<br />
+Key +<br />
Used to increase a a value<br />
Used to enter Info and Serivce during the curve adjustments<br />
Keys (+ & - )= ESC<br />
By pressing + and - at the same time, the ESCAPE function is perfomed:<br />
to enter a lower level menu<br />
Lock+unlock codes<br />
Flame<br />
Open valves<br />
Ignition transformers energised<br />
Fan motor energised<br />
Oil pre-heater energised<br />
Plant heat request<br />
Parametere setting mode<br />
Info mode<br />
Service mode<br />
Closing actuator<br />
Opening actuator<br />
Unit measure<br />
6<br />
P<br />
V h min s %