Owner's Manual - Radio Shack

43-935.fm Page 12 Friday, January 14, 2000 3:07 PM
DISABLING THE LINE 2
INDICATOR
If you have only one telephone line, the
LINE 2 indicator lights and LINE 2 EX-
TENSION appears on the display. Follow
these steps to disable the LINE 2 indicator.
1. Press REVIEW or repeatedly
until the call total appears.
2. Press REVIEW until LINE 2 EN-
ABLED appears (about 3 seconds).
3. Press REVIEW or . LINE 2
DISABLED appears.
4. Press DELETE to return to the current
time display.
ADJUSTING THE DISPLAY
CONTRAST
1. Press REVIEW or repeatedly
until the call total appears.
2. Press and hold down REVIEW
for about 3 seconds until CONTRAST
X appears.
3. Within 30 seconds, repeatedly press
REVIEW or to adjust the display’s
contrast from 1 to 8.
12
Notes:
• If CONTRAST X disappears before
you press REVIEW or, repeat
Steps 1–3.
• If you did not connect an AC
adapter, you can only adjust the
display contrast from 1 to 3, and
only after you pick up the handset.
4. When you finish adjusting the contrast,
press DELETE to return to the
main display.
SETTING THE RINGER
VOLUME
To set the ringer’s volume for LINE 1 or
LINE 2, set the correlating L1 RINGER or
L2 RINGER to HIGH, LOW, or OFF.
Note: You can still answer calls if you
hear an extension phone ringing, and
you can still make calls.
SETTING THE DIALING
MODE
Set TONE/PULSE for the type of service
you have, tone or pulse. If you are not
sure which type you have, do this test.
1. Set TONE/PULSE to TONE.
2. Pick up the handset and listen for a
dial tone.