Owner's Manual - Radio Shack

More documents

Recommendations

Info

PREPARATION INSTALLING BATTERIES Your phone requires two AA batteries (not supplied) for power. For the best performance and longest life, we recommend <strong>Radio</strong><strong>Shack</strong> alkaline batteries. Note: The batteries protect the phone’s memory during power failures. If you do not connect the supplied AC adapter, the batteries cannot power all the phone’s functions. (See “Connecting AC Power” on Page 11.) Cautions: • Use only fresh batteries of the required size and recommended type. • Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities. Follow these steps to install batteries. 1. Use a flat blade screwdriver to loosen the screw on the battery compartment cover on the bottom of the phone, and remove the cover. 2. Place the batteries in the compartment as indicated by the polarity symbols (+ and –) marked inside. 3. Replace the cover and secure it with the screw. When appears on the display or the display dims, replace the batteries. Warning: Dispose of old batteries promptly and properly. Do not burn or bury them. 8 43-935.fm Page 8 Friday, January 14, 2000 3:07 PM Caution: If you do not plan to use the the phone for a month or more, remove the batteries. Batteries can leak chemicals that can destroy electronic parts. Notes: • If you replace the batteries, have fresh batteries on hand before you begin. You must install fresh batteries within 1 minute after removing the old batteries. Otherwise, you might lose the information stored in the system. • When you are replacing the batteries, do not press any buttons on the system after you remove the old batteries. Doing so might erase all stored information from the system.
43-935.fm Page 9 Friday, January 14, 2000 3:07 PM SELECTING A LOCATION You can place the phone on a desk top or table, or mount it on a standard wall plate. Select a location that is: • near an accessible AC outlet • near a telephone line jack • out of the way of normal activities • away from electrical machinery, electrical appliances, metal walls or filing cabinets, wireless intercoms, alarms, and room monitors Note: The base’s location affects the phone’s range. If you have a choice of several locations, try each to see which provides the best performance. MOUNTING THE SYSTEM Attaching the Stand To mount the phone on a wall or desk top, you need to attach the supplied stand to the phone. To place the phone on a desk top, insert the tab on the narrow end of the stand into the upper center slot. Then snap the two spring tabs on the wide end of the stand into place. Phone’s Upper Half Narrow End Spring Tabs Upper Center Slot To mount the phone on a wall plate or directly on the wall, insert the tab on the narrow end of the stand into the lower center slot. Then snap the two spring tabs on the wide end of the stand into place. Stand Stand Phone’s Lower Half To remove the stand from the phone, while pressing and holding in both spring tabs, gently pull up the wide end of the stand and lift it off. 9
Page 1 and 2: 43-935.fm Page 1 Friday, January 14
Page 7: 43-935.fm Page 7 Friday, January 14

Owner's Manual - Radio Shack

Create successful ePaper yourself

Delete template?

Save as template?