1 HQI 2000 W/ D/ S bulb 37601 - Pani Projection and Lighting

Architecture Projector ARC 2/ HQI PANI Projection and Lighting Vertriebs GmbH.
Contents
Status of August 2002 Page
Important !
1) Scope of delivery ...........................................................................2
2) Technical data................................................................................2
3) Accsessories..................................................................................2
4) Setting up the projector ................................................................3
3.1) Yoke assembly ..........................................................................3
3.2) Projector angle of inclination .....................................................3
5) Electrical connections...................................................................3
6) Front condenser lens ....................................................................3
6.1) Fitting front condenser lens .....................................................3
7) Fitting accessories into the front panel .......................................4
7.1) Fitting slide carrier and adjusting slide.....................................4
7.2) Installing objective in objective adapter ...................................4
7.2.1) Setting up objective in projector ..............................................4
8) Control panel on projector ............................................................4
9) Control panels on ballast ..............................................................5
9.1) Top control panel.....................................................................5
9.2) Side control panel....................................................................5
10) Operating modes ...........................................................................5
10.1) Manual at ballast .....................................................................5
10.2) Remote ignition via DMX 512 ..................................................5
10.3) Timer function..........................................................................5
11) Removing projector cover.............................................................6
11.1) Fitting HQI bulb........................................................................6
11.2) Cleaning condenser.................................................................6
12) Condenser ......................................................................................6
13) Projection diagram ........................................................................7
14) Electrical schematic ......................................................................8
15) Dimension drawings......................................................................9
16) Itemised drawings..................................................................... 10, 11
17) Appendix: Electronic Time Switch .......................................... 12 – 16
The manual below shows the reference numbers in itemised drawings or the figures only
in abbreviated form:
e.g. drawing 2/ position 10 = (fig.2/ 10)
or figure 6 = (fig.6)
Itemised drawings are on pages 10 and 11
1