USFK Reg 690-118 Qualification Standards for KN

J-4. Information on ROKG licensing requirements and testing procedures may be obtained from the
Human Resources Development Service of Korea (HRDSK) and its regional offices (ROs) located
throughout Korea. Addresses and telephone numbers for the HRDSK and its regional offices are
provided in Appendix L.
J-5. ROKG licensing requirements and testing procedures for special heavy equipment not covered
under Korea Construction Equipment Management Law or Road Traffic Law are administered by the
heavy equipment license section at the city or provincial civil affairs office concerned.
J-6. ROKG license requirements and test procedures are subject to change without prior notice. The
appropriate ROKG agency should be contacted for current information on licensing requirements and
testing procedures.
J-7. USFK PERFORMANCE TEST. Applicants must successfully pass a USFK performance test for
the type of equipment to be operated (see Appendix M).
J-8. SPECIALIZED EXPERIENCE. Specialized experience is progressively responsible experience
operating and/or supervising the operation of the specific type of equipment of the position to be filled.
J-9. QUALITY OF EXPERIENCE. Applicants for leader positions and above must have 1 year of
specialized experience with the type of equipment operated, comparable to the next lower level in that
field. Applicants for Senior Leader and Foreman positions will also be rated as qualified if they have 2
years of specialized experience with the type of equipment operated, comparable to two job levels
below the job for which being considered.
J-10. ENGLISH ABILITY. Each component establishes requirements for English ability and
procedures for English proficiency tests.
38
USFK Reg 690-118, 19 October 2006