Library manual XBTGC Expert I/O High speed counting | 3 MB

Special I/O
Local and Special I/O Overview
Introduction
Special I/O Types
The XBT GC HMI Controller supports Local I/Os (see Magelis XBTGC HMI
Controller, Programming Guide). There are:
12 hardware inputs and 6 hardware outputs for the local I/Os of the
XBT GC 1100 HMI Controller
16 hardware inputs and 16 hardware outputs for the local I/Os of the
XBT GC 2120 HMI Controller and the XBT GC 2230 HMI Controller
The local I/O can be configured as special I/O. Special I/Os include:
High Speed Counter (HSC) (see page 26)
Pulse Train Output (PTO) (see Magelis XBTGC HMI Controller , Pulse Train
Output, Pulse Width Modulation, XBTGC Library Guide),
Pulse Width Modulation (PWM) (see Magelis XBTGC HMI Controller , Pulse
Train Output, Pulse Width Modulation, XBTGC Library Guide) output
Pulse Latch Input (PLI) (see Magelis XBTGC HMI Controller , Pulse Train Output,
Pulse Width Modulation, XBTGC Library Guide)
Special I/O Configuration
Special I/Os are configured in four Groups. Each Group has two inputs (In and In+1 of Group n) and one output (Qn of Group n), as shown in the diagram below:
NOTE: Any remaining I/Os can be configured as normal I/O. (see page 15).
14 04/2012