System x3630 M3 Type 7377: Installation and User?s Guide

More documents

Recommendations

Info

System-board DIMM connectors The following illustration shows the DIMM connectors on the system board. 22 System x3630 M3 Type 7377: Installation and User’s Guide
System-board external connectors The following illustration shows the external input/output connectors on the system board. Chapter 2. Installing optional devices 23
Page 1: System x3630 M3 Type 7377 Installat
Page 4 and 5: Note: Before using this information
Page 6 and 7: Online-spare memory . . . . . . . .
Page 8 and 9: vi System x3630 M3 Type 7377: Insta
Page 10 and 11: Important: Each caution and danger
Page 12 and 13: Statement 2: CAUTION: When replacin
Page 14 and 15: Statement 4: ≥ 18 kg (39.7 lb)
Page 16 and 17: CAUTION: Hazardous moving parts are
Page 18 and 19: The following illustration shows a
Page 20 and 21: Related documentation where e is th
Page 22 and 23: Notices and statements in this docu
Page 24 and 25: Table 1. Features and specification
Page 26 and 27: Director. For more information, see
Page 28 and 29: IBM Systems Director v Startup (boo
Page 30 and 31: Rear view Flashing rapidly (4 times
Page 32 and 33: AC power LED DC power LED Power-sup
Page 34 and 35: v You can turn off the server from
Page 36 and 37: Server components 5. To ship the se
Page 40 and 41: System-board jumpers This section d
Page 42 and 43: System-board LEDs The following ill
Page 44 and 45: Fan board connectors The following
Page 46 and 47: v Back up all important data before
Page 48 and 49: Internal cable routing and connecto
Page 50 and 51: Rotating the optional hot-swap rear
Page 52 and 53: Removing the PCI riser-card assembl
Page 54 and 55: Slot 4 PCIe2 x8 (8) Slot 3 PCIe2 x1
Page 56 and 57: Until the battery is fully charged,
Page 58 and 59: c. Press the posts into the rings a
Page 60 and 61: 12. Install the ServeRAID adapter o
Page 62 and 63: To install a virtual media key, com
Page 64 and 65: If you have other devices to instal
Page 66 and 67: 5. Remove the air baffle (see “Re
Page 68 and 69: 11. Connect the LED signal cable an
Page 70 and 71: SATA 0 SATA 1 SATA signal cable 0 S
Page 72 and 73: CAUTION: Hazardous moving parts are
Page 74 and 75: Hot-swap backplane 2 signal cable (
Page 76 and 77: Fan 5 Fan 6 Fan cables Fan 5 connec
Page 78 and 79: Installing a memory module 4. Press
Page 80 and 81: v A minimum of one DIMM must be ins
Page 82 and 83: enable memory mirroring through the
Page 84 and 85: If you have other devices to instal
Page 86 and 87: Attention: v Microprocessors are to
Page 88 and 89:
Installation tool Handle Microproce
Page 90 and 91:
Thermal grease The thermal grease m
Page 92 and 93:
To install an ac power supply, comp
Page 94 and 95:
Completing the installation To comp
Page 96 and 97:
1 3 1. Shift the switch on the rear
Page 98 and 99:
Connecting the external cables The
Page 100 and 101:
84 System x3630 M3 Type 7377: Insta
Page 102 and 103:
Using the Setup utility v LSI Confi
Page 104 and 105:
cannot configure Turbo Mode setting
Page 106 and 107:
Passwords Select this choice to set
Page 108 and 109:
Use the backup copy of the server f
Page 110 and 111:
3. From the menu on the left side o
Page 112 and 113:
Using the remote presence capabilit
Page 114 and 115:
is supported for the cluster soluti
Page 116 and 117:
v When you create a RAID level-1 (m
Page 118 and 119:
Updating the firmware In addition,
Page 120 and 121:
104 System x3630 M3 Type 7377: Inst
Page 122 and 123:
Software service and support You ca
Page 124 and 125:
Important notes Cell Broadband Engi
Page 126 and 127:
U.S.A. In the request, be sure to i
Page 128 and 129:
Zulassungsbescheinigung laut dem De
Page 130 and 131:
114 System x3630 M3 Type 7377: Inst
Page 132 and 133:
Ethernet-link LED 15 external cable
Page 134:
ServerGuide (continued) features 92
show all

System x3630 M3 Type 7377: Installation and User?s Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?