ēKo Pro series User's Manual - Crossbow Technology

More documents

Recommendations

Info

© 2007-2008 Crossbow Technology, Inc. All rights reserved. Information in this document is subject to change without notice. Crossbow, IRIS, ēKo, TrueMesh and XMesh are registered trademarks of Crossbow Technology, Inc. Other product and trade names are trademarks or registered trademarks of their respective holders.
ēKo Pro Series User’s Manual Table of Contents 1 Introduction.............................................................................................................................1 1.1 ēKo Pro Series Overview............................................................................................... 1 1.2 ēKo Pro System Components ........................................................................................ 2 1.3 ēKo Pro System Overview............................................................................................. 5 2 ēKo Pro Hardware Overview ................................................................................................6 2.1 ēKo Gateway.................................................................................................................. 6 2.2 ēKo Base Radio ............................................................................................................. 7 2.3 ēKo Node ....................................................................................................................... 7 2.4 ēKo Sensors ................................................................................................................... 9 3 ēKo Gateway Set-up and Configuration.............................................................................11 3.1 Setting-up the ēKo Gateway ........................................................................................ 11 3.2 Setting up the ēKo base radio ...................................................................................... 12 3.3 Starting the system....................................................................................................... 12 3.4 Starting up ēKoView ................................................................................................... 13 4 ēKo Node Commissioning ....................................................................................................16 4.1 Pre-commissioning ...................................................................................................... 16 4.2 Commissioning ............................................................................................................ 16 4.3 Post-commissioning..................................................................................................... 17 4.4 Factory Reset Mode:.................................................................................................... 18 5 Deploying the ēKo system ....................................................................................................20 5.1 Deploying the ēKo base radio and gateway................................................................. 20 5.2 Deploying ēKo Nodes.................................................................................................. 24 5.3 Deploying ēKo Sensors ............................................................................................... 29 5.4 Configuring ēKoView.................................................................................................. 31 6 Data viewing using ēKoView ...............................................................................................34 6.1 Login Page ................................................................................................................... 34 6.2 Sensor Tab ................................................................................................................... 35 6.3 Chart Tab ..................................................................................................................... 44 6.4 Configure Tab.............................................................................................................. 53 6.5 Network Tab ................................................................................................................ 63 7 Appendix A. Advanced ēKo Gateway Administration .....................................................67 7.1 GatewayFinder tool to find the IP address of your ēKo gateway ................................ 67 7.2 Remote ēKo gateway Administration.......................................................................... 69 7.3 Access using Gateway Administration Page ............................................................... 72 Doc. # 7430-0710-01 Rev. A Page i
Page 1: Rev. A, April 2008 PN: 7430-0710-01
Page 5: ēKo Pro Series User’s Manual Abo
Page 8 and 9: 1.2 ēKo Pro System Components 1.2.
Page 10 and 11: ēKo Pro Series User’s Manual •
Page 12 and 13: 2.1 ēKo Gateway 2 ēKo Pro Hardwar
Page 14 and 15: ēKo Pro Series User’s Manual The
Page 16 and 17: 2.4.2 eS1201 ambient temperature an
Page 18 and 19: 3.2 Setting up the ēKo base radio
Page 20 and 21: ēKo Pro Series User’s Manual NO
Page 22 and 23: 4 ēKo Node Commissioning ēKo Pro
Page 24 and 25: ēKo Pro Series User’s Manual 10.
Page 26 and 27: 5 Deploying the ēKo system 5.1 Dep
Page 28 and 29: The Table 5-1 summarizes the featur
Page 30 and 31: ēKo Pro Series User’s Manual An
Page 34 and 35: Deploying in Orchards Figure 5-7. E
Page 36 and 37: ēKo Pro Series User’s Manual •
Page 38 and 39: ēKo Pro Series User’s Manual If
Page 40 and 41: 6 Data viewing using ēKoView ēKo
Page 42 and 43: ēKo Pro Series User’s Manual NO
Page 46 and 47: ēKo Pro Series User’s Manual Sen
Page 48 and 49: Max Limit Alert level Min Limit Tab
Page 50 and 51: 6.3 Chart Tab ēKo Pro Series User
Page 52 and 53:
ēKo Pro Series User’s Manual 4.
Page 54 and 55:
6.3.2 Viewing chart data ēKo Pro S
Page 56 and 57:
Plot Type ēKo Pro Series User’s
Page 58 and 59:
6.3.7 Deleting a saved chart ēKo P
Page 60 and 61:
ēKo Pro Series User’s Manual NO
Page 62 and 63:
You will need to specify: 1. Alert
Page 64 and 65:
ēKo Pro Series User’s Manual 7.
Page 66 and 67:
Alert Mail Settings: ēKo Pro Serie
Page 68 and 69:
Edit an existing user: ēKo Pro Ser
Page 70 and 71:
ēKo Pro Series User’s Manual In
Page 72 and 73:
EXAMPLE ēKo Pro Series User’s Ma
Page 74 and 75:
7. Make a note of the IP address as
Page 76 and 77:
ēKo Pro Series User’s Manual sys
Page 78 and 79:
ēKo Pro Series User’s Manual Onc
Page 80 and 81:
ēKo Pro Series User’s Manual NO
Page 82 and 83:
7.3.4 Changing the ēKo Gateway tim
Page 84 and 85:
ēKo Pro Series User’s Manual Sel
Page 86 and 87:
WARNING ēKo Pro Series User’s Ma
Page 88 and 89:
To delete database, click on “Del
Page 90 and 91:
7.4 Direct connection to a PC using
Page 92 and 93:
ēKo Pro Series User’s Manual •
Page 94 and 95:
ēKo Pro Series User’s Manual For
Page 96 and 97:
WARNING ēKo Pro Series User’s Ma
Page 98 and 99:
8.1.3 How does the Watermark sensor
Page 100 and 101:
8.2.1 Installing the Sensor ēKo Pr
Page 102 and 103:
9 Appendix C. Accessories Antenna a
Page 104 and 105:
10.3.2 Identification and Protectio
Page 106:
Crossbow Technology, Inc. 4145 N. F
show all

ēKo Pro series User's Manual - Crossbow Technology

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?