ēKo Pro series User's Manual - Crossbow Technology

ēKo Pro Series User’s Manual
3. ēKoView requires a username and password to login. Type the default values below and
click on Sign In!.
Username: admin
Password: crossbow
NOTE: If you do not have Adobe’s Flash 9.x installed in your browser, you will be
prompted by your browser to install it. Follow the instructions given by your browser and then
retry the above steps.
For users on a corporate or university network, the hostname should be enough to allow users to
find the application through the browser. Most home routers do not support the means to use the
hostname. In those cases users will need to use the IP address of the ēKo gateway device. The IP
address of the ēKo gateway can be found either using the GatewayFinder tool or using the beep
sequence (see section 7.1).
3.4.3 Changing the time zone of the ēKo gateway
The ēKo Gateway ships pre-configured from the factory with US Pacific time zone. Since the
data is time-stamped relative to the time zone, users living is different time zone should change
this. The ēKo Gateway Administration page allows user to change this default time zone. Refer
to section 7.3.4 for details on how to do this.
Doc. # 7430-0710-01 Rev. A Page 15