USB Virtual Reality HID - Bradley University ECE department

More documents

Recommendations

Info

• Project Summary • Analysis • Block Diagram • Hardware • Inertial Sensors • Position Calculation • USB • Results • Questions === Agenda
Project Summary • Purpose: To create a USB HID that translates user movements into onscreen actions to provide a realistic interactive platform for PC games and other virtual environments. • Why?: To show that low-cost MEMS inertial sensors capable of providing accurate position data for a complex interactive experience.
Page 1: USB Virtual Reality HID by Weston T
Page 5 and 6: Goals • List of project goals: -
Page 7 and 8: • Gyroscopes - Measure °/sec Ana
Page 9 and 10: Human Movement 5DOF Compass Analog
Page 11 and 12: • IMU 5 DOF Hardware - 2-axis gyr
Page 13 and 14: Hardware • Wireless ZigBee - XBee
Page 15 and 16: • Parts List Table: Parts List Eq
Page 17 and 18: Schematic • USB Board Schematic
Page 19 and 20: Noise • Problem High Frequency N
Page 21 and 22: Offset • Problem Offset, zero-ra
Page 23 and 24: Sensor Data • Data after calibrat
Page 25 and 26: Position - Basics • Gyroscopes me
Page 27 and 28: Code • Integration Summation - Ba
Page 29 and 30: Feedback • Integration of error
Page 31 and 32: USB • Silicon Labs C8051F340 = US
Page 33 and 34: • Problems - Direct Input USB •
Page 35 and 36: Results • Future Suggestions - Wr
Page 37 and 38: References [1] Silicon Labs, C8051F
Page 39 and 40: Test Platform • Yaw = 0° - 360°
Page 41 and 42: • ADC0 Interrupt SW Flowcharts

USB Virtual Reality HID - Bradley University ECE department

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?