material safety data sheet manufacturer: maxim chemical ...

MATERIAL SAFETY DATA SHEET
MANUFACTURER: MAXIM CHEMICAL INTERNATIONAL LTD.
1305 HALIFAX STREET, REGINA, SK S4R 1T9
PHONE: (306) 347-0444
SECTION (1): PRODUCT IDENTIFICATION AND USE
PRODUCT NAME: WT-565
PRODUCT USE: HOT WATER BOILER TREATMENT
WHMIS CLASSIFICATION: E
TDG CLASSIFICATION: Does not apply
SECTION (2): HAZARDOUS INGREDIENTS
CAS # Range % (by weight)
Sodium Hydroxide 1310-73-2 1.0-5.0
LD50 (oral, rat): 340 mg/kg
LD50 (dermal): 1350 mg/kg
LC50: Not available
Sodium Molybdate 7631-95-0 3.0-7.0
LD50 (oral,rat): 520 mg/Kg
LD50 (dermal): Not Available
LC50: Not Available
SECTION (3): PHYSICAL DATA (Typical values. May vary from sample to sample)
Physical State: Liquid
Appearance and Odour: Amber liquid with mild odour
Boiling Point: 100 0 C approximately
Specific Gravity: 1.10
Solubility in Water: Soluble
pH: 12.9
Odour Threshold: Not available
Vapour Pressure: Not available
Vapour Density: Not available .../2

PRODUCT NAME: WT-565 (cont'd) Page 2
SECTION (3): PHYSICAL DATA (cont'd)
Evaporation Rate: Not available
Freezing Point: Not available
Coefficient of Water/Oil Distribution: Greater than 1.0
SECTION (4): FIRE AND EXPLOSION HAZARD DATA
Flash Point (Closed cup): None to boiling
Extinguisher Media: Product not flammable. Use
extinguishing media suitable for
surrounding fires.
Special Fire Fighting Procedures: Wear full protective equipment
and use a NIOSH/MSHA
approved self contained
breathing apparatus for fire
fighting situations. Use water
spray cool all nearby fire exposed
containers.
Unusual Fire and Explosion Hazard: None known
Flammable Limits: Not known
Auto-ignition Temperature: Not known
Conditions of Flammability: None
Explosion Data:
Sensitivity to Mechanical Impact: None
Sensitivity to Static Discharge: None
SECTION (5): REACTIVITY DATA
Stability: Stable
Incompatibility (Materials to avoid): Strong Acids
Hazardous Decomposition Product: Carbon dioxide.
Hazardous Polymerization: Will not occur
SECTION (6): TOXICOLOGICAL PROPERTIES
Route of Entry Information: Skin and eye contact
Irritancy: The product is corrosive.
Effects of Accute Exposure to Product: product exposure may cause
burns and damage to eyes and
skin.
Effect of Chronic Exposure to Product: None known
Exposure Limits: Not available
Sensitization to Product: Not available .../3

PRODUCT NAME: WT-565 (cont'd) Page 3
SECTION (6): TOXICOLOGICAL PROPERTIES (cont'd)
Carcinogenicity: None known
Reproductive Toxicity: None known
Teratogenicity: None known
Mutagenicity: None known
Name of Toxicologically Synergistic Product: None known
SECTION (7): PREVENTATIVE MEASURES
Respiratory Protection:
None required. If inhalation of concentrated product mist or spray is likely use a
NIOSH approved dust/mist respirator.
Ventilation:
Use with good general ventilation.
Protective Gloves:
Use rubber or plastic gloves.
Eye Protection:
Wear chemical safety glasses or face shield when handling concentrate.
Disposal Procedures for Spills or Leaks:
Wear protective equipment. Dike and contain large spills. Pump spill into an approved
waste container. For small spills soak up with suitable absorbent and dispose into an
approved waste container. For small spills soak up with suitable absorbent and
dispose into an approved waste container. Keep material away from sewers and
natural waters.
Waste Disposal Method:
Reuse if possible or otherwise dispose of in accordance with all local, provincial or
federal regulations.
Storage and Handling Procedures:
Use good industrial hygiene. Do not get into eyes, on skin or clothing. Keep container
closed when not in use. Store upright. Keep from freezing. Do not mix with any other
chemicals.
SECTION (8): FIRST AID PROCEDURES
EYES: Flush with plenty of water for 15 minutes. Get medical attention.
SKIN: Wash well with plenty of water for 15 minutes. If skin irritation
develops contact a physician.
INHALATION: Remove to fresh air.
INGESTION: Give plenty of water to drink. Do not induce vomiting. Call a
physician.
../4

PRODUCT NAME: WT 565 (cont'd) Page 4
SECTION (9): PREPARATION INFORMATION
Prepared by Technical Advisory services. Phone: (306) 347-0444
Date: February 4, 2000
Revised: February 4, 2003, February 4, 2006
The information provided in this Material Safety Data Sheet has been obtained from
sources believed to be reliable. MAXIM CHEMICAL INTERNATIONAL LTD. provides
no warranties expressed or implied and assumes no responsibility for the accuracy or
the completeness of the data contained herein.
MSDS-ID 1501565