material safety data sheet manufacturer: maxim chemical ...

MATERIAL SAFETY DATA SHEET
MANUFACTURER: MAXIM CHEMICAL INTERNATIONAL LTD.
1305 HALIFAX STREET, REGINA, SK S4R 1T9
PHONE: (306) 347-0444
SECTION (1): PRODUCT IDENTIFICATION AND USE
PRODUCT NAME: DEGREASER 202
PRODUCT USE: DEGREASING SOLVENT
WHMIS CLASSIFICATION: B3, D2B
TDG CLASSIFICATION: Exempt
SECTION (2): HAZARDOUS INGREDIENTS
CAS # Range % (by weight)
Aromatic Naphtha (Petroleum) Solvent Blend Mixture 40.0-60.0
Light Aromatic (60 - 100% wt) 6472-95-6
Heavy Aromatic (10 - 30 % wt) 6472-96-7
LD50 (oral, rat) = >4700 mg/kg
LD50 (dermal) = >3000 mg/kg
LC50 = Not Available
Petroleum Solvent 64742-94-5 5.0-10.0
LD50 (oral, rat) = 3000 mg/kg
LD50 (dermal) = >3000 mg/kg
LC50 = Not Available
Ethylene Glycol Monobutyl Ether 111-76-2 1.5-5.0
Exposure Limits: ACGIH TLV 25 ppm TWA
LD50 (oral, rat) = 1746 mg/kg
LD50 (dermal, rabbit) = 435 mg/kg
LC50 (mouse) = 700 ppm, 7hr.
.../2

PRODUCT NAME: DEGREASER 202 (cont'd) Page 2
SECTION (3): PHYSICAL DATA (Typical values. May vary from sample to sample)
Physical State: Liquid
Appearance and Odour: Pale yellow liquid with aromatic odour.
Boiling Point: 98 o C
Specific Gravity: 0.90
Solubility in Water: Emulsifiable
pH: Does not apply.
Odour Threshold: No data
Vapour Pressure: 5.5 mm Hg (20 o C)
Vapour Density: 4.5 (Air = 1)
Evaporation Rate: Less than 1.0 (Butyl Acetate = 1)
Freezing Point: Not Available
Coefficient of Water/Oil Distribution: Not Available
SECTION (4): FIRE AND EXPLOSION HAZARD DATA
Flash Point (Closed cup): 57 o C (Combustible according to
WHMIS-Class B3)
Extinguisher Media: Dry chemical or alcohol foam, carbon
dioxide, water in the form of fog. Use
extinguishing media suitable for
surrounding fires.
Special Fire Fighting Procedures: Wear full protective equipment
including self contained breathing
apparatus for large fires. For small fires
use a portable fire extinguisher. Use
water spray to cool all nearby fire
exposed surfaces.
Unusual Fire and Explosion Hazard: Vapours heavier than air may collect in
low areas where ventilation is poor.
May form flammable mixtures with air
at or above the flash point.
Flammable Limits: Not known
Auto-ignition Temperature: Not known
Conditions of Flammability: Excessive heat, sparks, open flames
and other sources of ignition.
.../3

PRODUCT NAME: DEGREASER 202 (cont'd) Page 3
SECTION (4): FIRE AND EXPLOSION HAZARD DATA (cont'd)
Explosion Data:
Sensitivity to Mechanical Impact: Not Available.
Sensitivity to Static Discharge: Not Available.
Hazardous Combustion Products: Decomposition may produce oxides of
carbon.
SECTION (5): REACTIVITY DATA
Stability: Stable under normal storage
conditions.
Incompatibility (Materials to avoid): Strong oxidizers and acids.
Hazardous Decomposition Product: Carbon oxides and other noxious
fumes upon thermal decomposition.
Hazardous Polymerization: Will not occur
SECTION (6): TOXICOLOGICAL PROPERTIES
ROUTE OF ENTRY INFORMATION: Skin, eye contact and inhalation
Irritancy: Irritating to skin, eyes, and
respiratory system.
Effects of Accute Exposure to Product: Product exposure may irritate
skin and eyes. Prolonged
inhalation of vapours or mists
may cause respiratory irritation,
headaches, nausea, etc. Also
may be harmful if absorbed
through skin. Ingestion may
cause gastrointestinal and
abdominal discomfort, and
symptoms similar to inhalation.
Small amounts of liquid aspirated
into lungs during ingestion or
from vomiting may cause mild to
severe pulmonary injury.
.../4

PRODUCT NAME: DEGREASER 202 (cont'd) Page 4
SECTION (6): TOXICOLOGICAL PROPERTIES (cont'd)
Effect of Chronic Exposure to Product: Prolonged or repeated exposure
may cause skin irritation or
dermatitis. Also may cause blood
disorders through skin absorption
of ethylene glycol monobutyl
ether (based on animal test data).
Exposure Limits: See Section 2 under Hazardous
Ingredients.
Sensitization to Product: No data
Carcinogenicity: None known
Reproductive Toxicity: None known
Teratogenicity: None known
Mutagenicity: None known
Name of Toxicologically Synergistic Product: None known
SECTION (7): PREVENTATIVE MEASURES
Respiratory Protection:
If exposed to vapours or mists, and depending on the exposure level, wear an
approved half-face or full face dust/mist and organic vapour respirator.
Engineering Controls:
Good general ventilation or local exhaust ventilation for product used in confined
areas.
Protective Gloves:
Nitrile, neoprene or viton gloves.
Eye Protection:
Use Chemical goggles, safety goggles or face shield.
Disposal Procedures for Spills or Leaks:
Wear protective equipment. Extinguish all nearby sources of ignition. Keep material
away from sewers. Dike and contain large spills. Pump spill into an approved,
flammable waste container. For small spills soak up with a suitable absorbent such as
clay, soil, or commercially available absorbents and scoop int an approved flammable
waste container.
Waste Disposal Method:
Reuse if possible, or otherwise dispose of in accordance with all local, provincial or
federal regulations.
Storage and Handling Procedures:
Use good industrial hygiene. Avoid contact with skin, eyes and clothing. Avoid
breathing vapours or mists. Use with adequate ventilation. Store in a cool dry place
away from all sources of ignition and incompatibles. Keep container tightly closed
when not in use. Use proper grounding procedures when handling. Empty container
may contain flammable residues/vapours. Store at temperatures below 30 o C.
Other Protective Equipment:
Rubber apron or long sleeved clothing. Eye wash and shower are recommended in
the immediate work area. .../5

PRODUCT NAME: DEGREASER 202 (cont'd) Page 5
SECTION (8): FIRST AID PROCEDURES
EYES: Flush with plenty of water for 15 minutes. Get medical attention.
SKIN: Wash well with plenty of water for 15 minutes. If skin irritation
develops contact a physician.
INHALATION: Remove to fresh air. If breathing is difficult give oxygen. Call a
physician.
INGESTION: Give plenty of water to drink. Do not induce vomiting. Call a
physician.
SECTION (9): PREPARATION INFORMATION
Prepared by Technical Advisory services. Phone: (306) 347-0444
Date: June 3, 1999
Revised: June 3, 2002; June 3, 2005
The information provided in this Material Safety Data Sheet has been obtained from
sources believed to be reliable. MAXIM CHEMICAL INTERNATIONAL LTD. provides
no warranties expressed or implied and assumes no responsibility for the accuracy or
the completeness of the data contained herein.
MSDS-ID 1400450