Downloaded - Kodak

Section 4: Replenisher System
G128_4306HCA
G128_4306HC
PROCESSOR
TANK
VALVE
CHECK
VALVE
3 WAY
VALVE
CAL
BIB
FLOW
MONITOR
Replenisher System
The REPLENISHER SYSTEM maintains chemistry at the correct strength in relation to the film that runs through
the PROCESSOR. A single-board computer in the REPLENISHER RACK determines replenisher rates. Depending
on the amount of film and film type, the appropriate REPLENISHER PUMP energizes. The PUMP pumps the
REPLENISHER chemistry from the BIB through the PUMP, through a FLOW MONITOR, through 3-WAY
VALVE and QUICK DISCONNECT, through a series of CHECK VALVES and HOSES, and into the bottom of the
TANK. The FILM DETECTOR, at the entrance of the wet section, detects the amount of film. The FILM
DETECTOR sends a signal to the SBC as to whether the PROCESSOR is transporting film or leader. When the film
is spliced, the type of film is detected. This data is input into the computer at the start of a film batch.
TG2044-1 – 06APR99 15
RUN
PUMP
QUICK
DISCONNECT
CHECK
VALVE