354 268-21 - heidenhain
354 268-21 - heidenhain
354 268-21 - heidenhain
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Tool Management<br />
MANUALplus differentiates between the following tool types:<br />
Lathes<br />
Recessing tools<br />
Threading tools<br />
Drills<br />
Tapping tools<br />
Millers (cutters)<br />
See the list at right to allocate individual tools to the tool types.<br />
Information regarding tool data<br />
The datum for determining the “Setup dimensions X, Z“ is based on<br />
the characteristic shape of each tool. The graphic support window describes<br />
the reference-point position for the selected tool type.<br />
Tool orientation: Determines the position of the tool tip, setup angle<br />
direction, reference-point position, etc.<br />
Driven tool: Determines whether the main spindle or a driven tool is<br />
turning to drill the centered bore hole.<br />
If the direction of rotation is defined, M3/M4 is automatically generated<br />
for the spindle or for the secondary spindle.<br />
Tool parameters whose identification letters are shown in gray<br />
can be entered optionally. MANUALplus uses these parameters<br />
when specific cycle parameters are not entered, when<br />
plunging angles or feed rates need to be calculated, etc.<br />
With driven tools, the cutting data always refer to the<br />
auxiliary spindle.<br />
Lathes<br />
Roughing tools<br />
Finishing tools<br />
Fine finishing tools<br />
Copying tools<br />
Button tools<br />
Recessing tools<br />
Plunging tools<br />
Undercutting tools<br />
Cutting-off tools<br />
Parting tools<br />
Threading tools<br />
All kinds of threading tools except tapping tools<br />
Drilling Tools<br />
Center drills<br />
Spot drills<br />
Twist drills<br />
Reversible carbide tip drills<br />
Counterborers and countersinkers<br />
Reamers<br />
Tapping tools<br />
All kinds of tapping tools<br />
Milling tools<br />
Slot (groove) cutting tools<br />
End milling tools<br />
Thread milling tools<br />
Tool Management<br />
109