Instruction Manual - Magnetrol International
Instruction Manual - Magnetrol International
Instruction Manual - Magnetrol International
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
➀ With housing drain, CSA drops Group E and FM drops Group C.<br />
➁ Models B10 and B15 with “HS” switches and all Model C10 and C15 are not ATEX approved.<br />
➂ IEC Installation <strong>Instruction</strong>s:<br />
The cable entry and closing devices shall be Ex d certified suitable for the conditions of use<br />
and correctly installed.<br />
For ambient temperatures above +55° C or for process temperatures above +150° C, suitable<br />
heat resistant cables shall be used.<br />
Heat extensions (between process connection and housing) shall never be insulated.<br />
Special conditions for safe use:<br />
When the equipment is installed in process temperatures higher than +85° C the temperature<br />
classification must be reduced according to the following table as per IEC60079-0.<br />
Maximum Process<br />
Temperature<br />
4.3 Specifications<br />
Temperature<br />
Classification<br />
< 85° C T6<br />
< 100° C T5<br />
< 135° C T4<br />
< 200° C T3<br />
< 300° C T2<br />
< 450° C T1<br />
These units are in conformity with IECEx KEM 05.0020X<br />
Classification Ex d IIC T6<br />
T ambient -40° C to +70° C<br />
4.3.1 Basic Electrical Ratings<br />
Displacer<br />
4.3.2 Pressure/Temperature Ratings<br />
Switch Series and Non-Inductive Ampere Rating<br />
B C D F HS O Q<br />
120 VAC 15.00 15.00 10.00 0.25 5.00 15.00 15.00<br />
240 VAC 15.00 15.00 — — 5.00 15.00 15.00<br />
24 VDC 6.00 10.00 10.00 4.00 5.00 — 6.00<br />
120 VDC 0.50 1.00 10.00 0.30 0.50 1.00 0.50<br />
240 VDC 0.25 0.50 3.00 — 0.25 0.50 0.25<br />
Threaded Models* 800 psig @ +100° F (55 bar @ +38° C)<br />
250 psig @ +400° F (17 bar @ +204° C)<br />
Flanged Models Limited to the pressure rating of the selected flange or displacer. Cast iron flanges are flat face type conforming to<br />
ANSI dimensional specifications<br />
Low Pressure 25 psig @ +200° F (1.7 bar @ +93° C)<br />
Proof-er Models<br />
Medium Pressure 125 psig @ +300° F (8.6 bar @ +149° C)<br />
Proof-er Models<br />
*Models with stainless steel displacers are rated 720 psig @ +100° F (50 bar @ +38° C)<br />
45-610 Displacer Type Liquid Level Switches and Proof-er ® Switches 13