Aprilia MA MY 50 Workshop manual - Scootergrisen
Aprilia MA MY 50 Workshop manual - Scootergrisen
Aprilia MA MY 50 Workshop manual - Scootergrisen
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Oil pump - Starter motor <strong>MA</strong><strong>50</strong> - <strong>MY</strong><strong>50</strong><br />
Water pump cover - refit<br />
Fit the water pump cover with its O-ring and secure it<br />
with the three screws (1). Connect up the water inlet<br />
tube and the cylinder water delivery tube, securing<br />
them with the tube clamps (2).<br />
Torque wrench setting: 7 Nm (5.163 ft-lb)<br />
Starter motor - remove<br />
If there is a fault in the starter motor , check the electrical<br />
connections before removing it, repairing them if<br />
necessary .<br />
Remove the two screws that secure the starter motor<br />
to the casing and remove the starter motor .<br />
Starter motor - refit<br />
Make sure that the O-ring is fitted properly into its slot,<br />
apply a thin layer of special oil seal grease (see<br />
Lubricants table) and then refit the starter motor ,<br />
securing it to the casing with the two screws.<br />
5-8<br />
Release 00 2000-01<br />
1<br />
1<br />
1<br />
ch. 5<br />
2<br />
2