Manual Inspecta Software

2.4.2.7 mvfg_blank (blank_time) , mfg_blank (blank_time)
Software
Synopsis: void mvfg_blank ( DWORD blank );
Description: the parameter blank_time is used to skip black pixels at the begin of a line. It
defines the number of pixelclocks *2 to lengthen the internal HSYNC
signal. It starts with the falling edge of the incomig HSYNC and is adjusted
to stop with the first valid pixel of the line. Thus blank_time defines the
length of the stored line. As this length must be divisible by 4, there are
blank_time values that result in an misaligned image.
Blank_time depends on the camera type and can be manually adjusted with
the programme ICAM.EXE or VCAM95.EXE.
Returns: --
Example: --
2.4.2.8 mvfg_pal (0/1), mfg_pal (0/1)
Synopsis: void mvfg_pal ( DWORD pal );
Description: defines number of lines per frame if an internal sync mode is selected or the
generation of an internal VSYNC signal if a linescan mode is selected
pal = 0 --> 525 lines, NTSC/RS-170 or 128 lines if linescan
pal = 1 --> 625 lines, CCIR or 256 lines if linescan
The above parameter description is valid for INSPECTA-2 Rev. 4,5,6 with
firmware code > IMP317.
Returns: --
Example: --
INSPECTA Software Rev. 1.47 Page 23