Pure Fun 12' Trampoline/Enclosure Set Model No. 9012TS Owner's ...

STEP 5 – FRAME PAD ASSEMBLY
You will need 2 adults to assemble the frame pad to keep it even during installation.
A. Lay the Frame Pad (2) over the trampoline so that the springs and the steel frame are covered. Ensure
that the Frame Pad covers all metal parts.
B. Make sure that the stitched flap of the frame pad is able to be folded under the top rail.
C. Attach elastic bands to the tramp mat as shown in figure C, but do NOT pull them too tight or they will
break off after a period of use. The bands require a certain amount of slack, as they are
attached to the jumping surface which will have significant vertical movement dur
ing use. Failure to leave slack in the bands will result in the bands tearing loose
from the pad, and/or the pad shifting off of the top rail upon use. For stability you should also
cross the band under itself when looping it around the top rail to prevent wear and tear on the stitched ends of
the elastic bands.
D.Once bands are secured, pull drawstring so the stitched flap fits under the top rail.
E.The trampoline pad should be the slightest bit loose so it “floats” a bit with movement. Keep in mind it
will require readjustment after a period of use.
F. STOP using the trampoline if it shifts during use, and have an adult readjust it.
Enclosure Parts List & Assembly Instructions on Next Page