removing the fc (forced convection) - This is a secure site - Whirlpool

REMOVING THE OVEN DOOR COMPONENTS
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug microwave oven or disconnect
power.
2. Lower the bottom cover (see page 4-2 for
the procedure).
3. To remove the oven door:
a) From the bottom of the oven, press
the locking arm on the user interface
board (UIB) connector to disengage it,
and disconnect the connector from the
chassis plug.
UIB Connector
4-10
b) Open the microwave oven door.
c) Remove the screw at the top of the
oven door hinge.
d) Close the oven door but do not latch it.
Lift the door, unhook the bottom hinge
pin from the bracket, and remove the
door.
Oven Door
Hinge Screw
e) Lay the oven door face down on a
padded surface to protect it.
f) Pull out and unclip the door wire channel
from the chassis cutout.
Door Wire Channel