removing the fc (forced convection) - This is a secure site - Whirlpool

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug microwave oven or disconnect
power.
2. Remove the microwave oven from its
mounting location (see page 4-17 for the
procedure).
3. Lift the two tabs and remove the center air
flow screen from the top of the cabinet.
Center Air Flow Screen
4. Remove the T10 torx screws from the left
and right air flow screens and remove the
screens from the top of the cabinet.
Left & Right Air Flow Screen Screws
REMOVING THE CABINET
4-18
5. Remove the three T10 torx screws from
the top of the cabinet.
6. Remove the T10 torx screw from the
power cord cover and remove the cover.
Power Cord Cover & Screw
Cabinet Top Screws
7. Remove the two T10 torx screws from
the left and right sides of the cabinet, and
the eight screws from the rear cabinet
flange.
Right Cabinet
Side Screw
Cabinet Rear
Screw (1 of 8)
8. Pull the cabinet toward the rear of the
unit, unhook the front top and side tabs
from the slots, and remove the cabinet
from the microwave oven.