Service Manual - MyLinkDrive
Service Manual - MyLinkDrive
Service Manual - MyLinkDrive
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
OPERATION PROCEDURE<br />
9. REMOVING THE HEAT EXCHANGER AND LEV<br />
(1) Remove the front panel (Refer to procedure 2) and the<br />
corner panel at right lower side.<br />
(2) Remove the electrical box (Refer to procedure 4) and the<br />
nozzle assembly (Refer to procedure 5).<br />
(3) Remove the motor band.<br />
(4) Remove the pipe thermistors (Refer to procedure 8).<br />
(5) Disconnect the connector (CN60) on the indoor controller<br />
board and the connector for ground wire. (See Photo 5)<br />
(6) Remove the screws fixing the left side of the heat<br />
exchanger. (See Photo 10)<br />
(7) Remove the heat exchanger with LEV.<br />
10. REMOVING THE ROOM TEMPERATURE THERMISTOR<br />
(1) Remove the front panel (Refer to procedure 2).<br />
(2) Remove the electrical box cover.<br />
(3) Remove the room temperature thermistor.<br />
(4) Disconnect the connector (CN20) on the indoor controller<br />
board.<br />
NOTE: When room temp. thermistor is replaced, be sure<br />
to use service parts No. R01 N20 202.<br />
Photo 16<br />
Screw (top cover)<br />
Water cover<br />
Nozzle assembly<br />
OCH515<br />
Screw (side cover)<br />
Switch holder<br />
Electrical box<br />
cover (top)<br />
Electrical box<br />
cover (side)<br />
Room temp.<br />
thermistor<br />
(TH21)<br />
Thermistor<br />
holder<br />
Screw<br />
(side cover)<br />
Holder of wireless<br />
controller board<br />
25<br />
Photo 13<br />
Screw (top cover)<br />
Water cover<br />
Nozzle assembly<br />
Photo 14<br />
Heat<br />
exchanger<br />
Photo 15<br />
Terminal<br />
block (TB2)<br />
Terminal<br />
block (TB5)<br />
Terminal<br />
block (TB15)<br />
PHOTOS<br />
Screw (side cover)<br />
Switch holder<br />
Fixture<br />
(right)<br />
Ground wire<br />
Electrical box<br />
cover (top)<br />
LEV<br />
Indoor controller board (I.B)<br />
Room temp. thermistor (TH21)<br />
Electrical box<br />
cover (side)<br />
Room temp.<br />
thermistor<br />
(TH21)<br />
Thermistor<br />
holder<br />
Screw<br />
(side cover)<br />
Holder of wireless<br />
controller board<br />
Fixture<br />
(right)