Repair Manual for Wheel Loader WL 30 - Wacker Neuson

7 Operator's platform and cab
Removing the grounding
strip
Removing the steering
column cladding
Removing the instrument
steering column
Fig. 355 Steering cover Fig. 356 Grounding point
Unscrew the 4 screws (Fig. 355,1).
Remove the cover (Fig. 355,2).
Unscrew the screw (Fig. 356,1) and remove the grounding cable.
Fig. 357 Upper cladding Fig. 358 Lower cladding
Unscrew the 4 screws (Fig. 357,2).
Unscrew the 4 screws (Fig. 357,3).
Carefully pull the upper steering column cladding (Fig. 357,4) apart so that
the screws (Fig. 358,1) are freed.
Unscrew the 4 screws (Fig. 358,1).
Unscrew the 2 screws (Fig. 358,3).
Remove the lower steering column cladding (Fig. 358,2).
Carefully connect the upper steering column cladding and screw in 1 screw
(Fig. 357,3) loosely.
Fig. 359 Steering attachment
Unscrew the 4 screws (Fig. 359,1).
Carefully set down the orbital steering valve (Fig. 359,3) to the rear.
4-160 1000239425 - WDF-6001-00EN
WL 30 - 10/2008-1 (WDF-7022-00EN)