ptdist - Nanyang Technological University

More documents

Recommendations

Info

$Elasticity modulus, hardness and fracture toughness of Ni3Sn4 ...$

Fig. 18. Surface modeling application (4) — Distributing BTF-based features. We can quickly arrange holes (BTF-based feature) on object surface by keying them at each distributed point generated by our tiling method. February 2, 2008 MINOR REVISION 29
Fig. 19. Surface modeling application (5) — Geometric textures: thorns and pyramids in shell space. Note that we have 3142, 874, and 10121 geometric features placed on HOLES3, LAURANA, and BUNNY (from top to bottom), respectively. February 2, 2008 MINOR REVISION 30
Page 1 and 2: Dual Poisson-Disk Tiling: An Effici
Page 3 and 4: I. INTRODUCTION Surface modeling is
Page 5 and 6: adius equal to half of this limit a
Page 7 and 8: D. Overview Figure 1 outlines our s
Page 9 and 10: Fig. 4. The construction of a corne
Page 11 and 12: Further than that, we need to speci
Page 13 and 14: it, and finally map the distributed
Page 15 and 16: • First of all, we properly assig
Page 17 and 18: Fig. 10. A tiling example - Generat
Page 19 and 20: TABLE II TIMING ON THE REFINEMENT P
Page 21 and 22: and mafter (see the table); m refer
Page 23 and 24: on the object surface. Then, we can
Page 25 and 26: [15] Matthias Eck, Tony DeRose, Tom
Page 27 and 28: Fig. 14. Surface modeling applicati
Page 29: Fig. 17. Surface modeling applicati

ptdist - Nanyang Technological University

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?