Memo Operating Instruct - Euroheat

Electric Ignition
The pellet furnace is fitted with an electric ignition. This starts to function together with the stove start program.
Ignition duty cycle: Approx. 6 min.
Emergency Operation – Heating Up Without Electrical Ignition
If the ignition cartridge of the unit fails, emergency operation may be performed using fire lighters.
Place a handful of pellets with the fire lighter in the cleaned fire trough, ignite them and then close the
combustion chamber door. Pressing the key starts the stove.
CAUTION: Do not use flammable liquids to preheat the stove.
Some Field Values
Pellet consumption depends on the size of the pellets. The larger the pellets the slower the feed and vice
versa.
A full pellet container will suffice approximately 16 hours at an output of 100% and approximately 50 hours
at an output of 30%.
(variations are possible due to pellet quality).
Fuel Addition
CAUTION when filling the stove with pellets.
Do not touch the hot stove with the pellet sack.
Remove any pellets that have not been put in the storage container immediately.
To prevent the fire from going out due to lack of fuel, we recommend that an adequate filling level is kept in
the storage container. Check the filling level often. The container lid should however always be kept closed
unless the container is being filled. Pellet container capacity (see “Technical data”).
© EUROHEAT DISTRIBUTORS (H.B.S) LTD. June 2011 25
Instructions Part Number IN1228 Ed 1