Release notes Sc1x3 @CHIP-RTOS V1.10 ... - Beck IPC Gmbh

CR Number: 1331
Type: Suggestion
Component: Int21h
Category: SWI 0x21 Service 0x31: Keep Process
Synopsis: Remove task.
Description: The "Terminate and Stay Resident" action should delete the RTOS task to reduce the RTX
resource usage.
Fix: Redesign DOS SW 0x21 service 0x31 so that memory is resized after task is terminated and
memory allocated to task is tagged as reserved for TSR.
Type: Suggestion, Component: RTOS API (2 item(s))
CR Number: 1325
Type: Suggestion
Component: RTOS API
Category: Selectable Real-Time Interrupt rate
Synopsis: Optional operation of SC1x3 at rates above 1000 Hz desired
Description: Allow CHIP.INI selection of SC1x3 Real-Time interrupt rate greater than 1000 Hz
Fix: Implemented.
CR Number: 1339
Type: Suggestion
Component: RTOS API
Category: Task Priority
Synopsis: A RTX_Get_Priority() API would be helpful in applications
Description: This will allow utility functions in applications to raise priority and then restore it back to what it
was without knowing the specifics of which thread it is operating on.
Fix: Add Change_Priority() function which read out and/or writes priority
Type: Suggestion, Component: SPI API (1 item(s))
CR Number: 1324
Type: Suggestion
Component: SPI API
Category: SPI bus mode
Synopsis: If different tasks use the SPI bus, allow that the different slave devices can use different SPI
modes.
Description: Extend the "SPI wait on semaphore call" so that SPI mode and divider is set, after the tasks gets
the semaphore.
Fix: Implemented new SPI CLIB call "spi_waiton_sem_setmode()"
Type: Suggestion, Component: Webserver (1 item(s))
CR Number: 1177
Type: Suggestion
Component: Webserver
Category: Argument length
Synopsis: Limited argument length
19 von 30