Manual (PDF) - certon systems GmbH

www.certon.de
Do not disconnect the connected device until the copy process is finished. As soon as the copy
process is finished, it will be reported by Display.
i
• Data will be copied into the AutoStorage folder where a sub-folder, labeled with the date and
time will be generated.
The AutoStorage folder cannot be deleted by the web interface to ensure that the data is not
accidentally deleted.
i
4. Quickstart
• To do a quick start with your studioRAID Blueline, please read the following chapter. If
problems emerge, please read the corresponding chapters in this manual.
• Ensure that the hard disk drives are properly located.
• Connect the power supply.
• Connect the LAN cable to your network.
• Make sure that a DHCP Server is available
• Switch on the studioRAID Blueline NAS.
• Wait until an IP-address is reported on the Display.
• Type in the IP-address in your web browser.
• The studioRAID Blueline Control-Center starts, login with username “admin” and password
“admin”.
• Change the administrator-password and memorize the new password.
• Generate the user accounts at “user administration”
• Define the network permissions for the users at “folder administration”
• The studioRAID Blueline NAS is now ready for use.
5. Placement of hard disks
• Insert the included hard disk drives in the studioRAID Blueline NAS
• Begin with the hard disk 1and insert it into the first bay
• Continue with the next hard disk and insert it in the next bay
• Insert all hard disk drives top down:
Seite 10