sentrol - DIY Alarm Forum
sentrol - DIY Alarm Forum
sentrol - DIY Alarm Forum
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
.........................................................................................................................................................................<br />
Commercial Applications<br />
APPLICATION<br />
INSTALLATION<br />
RECOMMENDED<br />
PRODUCTS<br />
“SILENT” ALARM FOR BANKS<br />
AND JEWELRY STORES<br />
Banks, jewelry stores, and other retail facilities with cash and valuables can be<br />
protected with a manually operated switch. Sentrol’s 3040 and 3045 feature<br />
internal magnetic contacts and an actuating lever with a magnet cradled in it.<br />
When the lever is pulled, the SPDT circuit closes or opens, activating the alarm.<br />
Mounted under a counter top or inside the kneehole of a desk, the device offers<br />
protection for employees in potentially high-risk businesses.<br />
Note: The 3040 has a separate latching LED circuit. It must be powered and reset<br />
by a push-button +5 to 12 VDC source in or mounted outside the alarm panel.<br />
The 3045 has no latching LED.<br />
Determine the best location for the actuating lever. It is most effective when<br />
mounted out of view but within convenient reach of the user.<br />
Make sure you allow at least 3" (7.62 cm) of clearance above the mounting surface<br />
to accommodate the actuating lever once it is fully open. The device can be<br />
mounted horizontally or vertically.<br />
Temporarily mount unit with tape and test for ease of operation. Mark holes for<br />
screws and a hole for leads.<br />
Drill pilot holes or start screws. Connect leads to terminal block inside housing.<br />
Snap cover plate in place.<br />
Test unit. Handle pulled approximately 30˚ from the normal locked position will<br />
activate alarm circuit and LED circuit — LED will light. With handle open, reset<br />
LED circuit by interrupting power to LED circuit. LED will go out.<br />
Close handle. Device is now fully re-armed.<br />
3040, 3045, 3050, 3055<br />
MAGNETIC CONTACTS<br />
Open 1” (30°) to<br />
activate switch<br />
WWW.<strong>DIY</strong>ALARMFORUM.COM<br />
3.71