Weinig Tools
Weinig Tools
Weinig Tools
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
PowerLock<br />
2.2 <strong>Weinig</strong> PowerLock 538<br />
2.2.1 General<br />
The <strong>Weinig</strong> PowerLock 538 is a heavy-duty cutter.<br />
All the relevant safety regulations and the instructions in<br />
this operating manual must be closely followed in order<br />
to ensure safe use and handling of this tool.<br />
Please read these instructions through carefully before<br />
using the tool.<br />
2.2.2 Intended use<br />
The profile cutterhead is only approved for mechanical<br />
feed systems and is used for the following purposes:<br />
Planing and profiling work on solid wood (hard and soft<br />
wood) and wood substitutes.<br />
Applications: see technical data.<br />
Chapter 1 Safety must be read through<br />
carefully and observed before using the<br />
tool.<br />
2.2.3 Special safety instructions for tool 538<br />
• Always use at least two clamping screws to tension<br />
the clamping ledges and profiled cutters.<br />
• When using slim profiled cutters, select clamping<br />
ledges of a length corresponding with that of the<br />
profiled cutters.<br />
• Remove any unused clamping screws when using<br />
shorter clamping ledges.<br />
• Check that the profiled cutters are correctly seated in<br />
the serration.<br />
• Insert all cutters in the serration in the same position<br />
(distance from bottom of groove).<br />
• Leitz DoubleBack system:<br />
Max. blank height 60 mm for Z = 2<br />
Max. blank height 70 mm for Z = 4<br />
Z4 tools have four holes at the end. The extent<br />
to which the cutters protrude can be seen here<br />
(max. from last serration to beginning of hole<br />
edge). The holes are also used for cleaning<br />
(with compressed air).<br />
538<br />
Tech. Dok. / WNW 850 02 / 02.2005.A / © MICHAEL WEINIG AG <strong>Weinig</strong> <strong>Tools</strong> 2-5<br />
DOKW0043