Weinig Tools
Weinig Tools
Weinig Tools
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Normal clamping<br />
3.4 <strong>Weinig</strong> cutterhead 500 / 510<br />
3.4.1 General<br />
The <strong>Weinig</strong> cutterhead 500 / 510 is a heavy-duty cutter.<br />
All the relevant safety regulations and the instructions in<br />
this operating manual must be closely followed in order<br />
to ensure safe use and handling of this tool.<br />
Please read these instructions through carefully before<br />
using the tool.<br />
3.4.2 Intended use<br />
The cutterhead is only approved for mechanical feed<br />
systems and is used for the following purposes:<br />
Planing and edge-jointing work on solid wood (hard and<br />
soft wood) and wood substitutes.<br />
Applications: see technical data.<br />
Chapter 1 Safety must be read through<br />
carefully and observed before using the<br />
tool.<br />
1 Straightening<br />
2 Edge-jointing on the right<br />
3 Planing the left<br />
4 Profiling on the right<br />
5 Planing the top<br />
6 Planing the bottom<br />
3.4.3 Special safety instructions for tool 500 / 510<br />
• Note the markings for the minimum cutter clamping<br />
length at the tool ends.<br />
• The cutters may only be adjusted with the aid of the<br />
corresponding setting devices.<br />
500<br />
Tech. Dok. / WNW 850 02 / 02.2005.A / © MICHAEL WEINIG AG <strong>Weinig</strong> <strong>Tools</strong> 3-11<br />
6<br />
3<br />
5<br />
4<br />
1<br />
2<br />
DOKW0062<br />
DOKW0039
Change language