Modular Automation Devices - Hager

Emergency lighting module
Application :
for residential and commercial
premises.
Installed in a consumer unit or
distribution board, the lamp can
be configured to light
automatically in the event of
power failure.
It can also be withdrawn from its
base, thereby acting as a mini
torch with an operating duration
of 1 hour 30min.
For technical information
see page 412
Designation Width in I Pack Cat.
17.5mm qty. ref.
Modular
devices
Emergency lighting module 3 1 EE960
EE960
Remote control for emergency light blocks
The remote control device
switches self contained emergency
lighting into neutral position
or into working position.
It permits each day after closing
down of premises, to switch off
self contained emergency lighting
to avoid the discharge of
battery.
The remote control is
recommended in premises for
public and in industrial or
commercial premises.
The device is a 2 position changeover
switch, with automatic
recall for switching off or on, of
self contained emergency lighting,
by delivering polarized current
impulses on the remote
control circuits (+ or -)
Connection capacity :
6 flexible wire
10 rigid wire
For technical information
see page 412
Designation Characteristics Width in I Pack Cat.
17.5mm qty. ref.
Remote control
to control up to 60 self
contained,
with an average consumption of
0,1 mA / 6 V
power supply :
230 V 50/60 Hz
output supply : 8,4 V ...
time delay for power supply :
24 hours before activation of
remote control
4 1
EE905
Remote control
to control up to 120 self
contained,
with an average consumption of
0,1 mA / 6 V
power supply :
230 V 50/60 Hz
output supply : 12 V ...
time delay for power supply :
24 hours before activation of
remote control
4 1 EE910
EE910
369