Installation and Maintenance Manual - Harken

More documents

Recommendations

Info

Winch exploded view with maintenance products G 1 G A G O Anti-seize Harken ® Grease Harken ® Pawl Oil A O A G G O O A 1Apply Harken ® grease on assy socket screw 2Apply Harken ® grease on drum gear UniPower Radial 12 Installation and Maintenance Manual
Winch assembly Make sure that the holes and drainage channels in the base of the winch are not obstructed Assemble the winch in the reverse order of the sequence in the section on disassembly. To tighten bolts, use the torque indicated in the disassembly procedure. When positioning the stripper arm, align the peeler with it. If the jaws have been disassembled, insert peeler between the two jaws, taking care that the letters TOP on the peeler are facing upwards. OIL To assemble the pawls: correctly position the spring in its housing as shown at left. Hold the spring closed and slide the pawl into its housing. Once in position, check that the pawls can be easily opened and closed with a finger. NOTICE Before assembly the winch check the correct position of the o-ring between the ring gear n°4 and the flange n°11 and the position of rollers between the ring gear n°4 and the gear carrier n°21. In case of doubt concerning the assembly procedure contact Harken ® Tech Service: techservice@harken.it UniPower Radial 13 Installation and Maintenance Manual
Page 1 and 2: Installation and Maintenance Manual
Page 3 and 4: Introduction - Technical characteri
Page 5 and 6: Once you have decided the correct m
Page 7 and 8: Motor electric wiring NOTICE Before
Page 9 and 10: Maintenance table Winches must be v
Page 11: Once the winch is disassembled, cle
Page 15 and 16: Exploded view 1/2 31 13 25 8 7 27 1
Page 17 and 18: Parts list UniPower 900 A A= drum i

Installation and Maintenance Manual - Harken

Create successful ePaper yourself

Delete template?

Save as template?