om, husqvarna, mz6128, 966613103, 2012-09, zero turn: consumer
om, husqvarna, mz6128, 966613103, 2012-09, zero turn: consumer
om, husqvarna, mz6128, 966613103, 2012-09, zero turn: consumer
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
OPERATION<br />
Moving Machine By Hand<br />
WARNING!<br />
No adjustments or maintenance should<br />
be carried out unless:<br />
• the engine stopped<br />
• the ignition key removed<br />
• the parking brake activated<br />
1<br />
2<br />
When pushing or pulling the mower, engage the IZT<br />
(Integrated Zero<strong>turn</strong> Transaxle) bypass linkages. The<br />
release levers are located on each side of the rear of<br />
the unit below the rear engine plate.<br />
1. Raise the deck to the highest (transport) position.<br />
2. Pull the release levers up and out of the keyhole<br />
slots. Release the levers with the head outside the<br />
bracket and held into the bypass setting.<br />
3. To reengage the IZTs to drive, reverse the above<br />
procedure.<br />
Load the machine into truck or trailer by driving up<br />
ramps in low gear. DO NOT LIFT! The machine is not<br />
intended to be lifted by hand.<br />
1. IZT locked into the bypass position<br />
2. Linkage lever, engaged<br />
Right side, IZT linkage<br />
WARNING!<br />
8058-059<br />
Use extreme caution when loading the<br />
machine into a truck or trailer using<br />
ramps. There is the possibility of serious<br />
injury or death if the machine falls off the<br />
ramps.<br />
WARNING!<br />
Bypass linkages are located close to the<br />
muffler. To prevent burns, the engine<br />
should be shut off and allowed to cool<br />
before the bypass linkage levers are<br />
handled.<br />
34