Road Racing FIM Sidecar World Championship ... - Spelregels
Road Racing FIM Sidecar World Championship ... - Spelregels
Road Racing FIM Sidecar World Championship ... - Spelregels
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2.3.34 Wheels<br />
The rear wheel and <strong>Sidecar</strong> wheel shall be enclosed down to the level of the<br />
<strong>Sidecar</strong> platform on the inside.<br />
The maximum width of the front wheel rim cannot exceed 9”.<br />
The maximum width of the rim for the rear wheel and sidecar wheel cannot<br />
exceed 11”.<br />
2.3.35 Tyres<br />
Slick tyres are authorised.<br />
1) The maximum width of the front tyre tread measured from the point where<br />
the wall of the tyre finishes and the tread pattern starts, to the point where<br />
the tread pattern stops and the wall of the tyre's other side starts (only the<br />
section of the tread pattern normally in contact with the ground is<br />
measured) shall not exceed 230 mm.<br />
2) The rear tyre shall not exceed 254 mm, measured like in point 1)<br />
3) When the springs are compressed to their maximum, there shall still remain<br />
a minimum wheel clearance of 15 mm to every fixed part.<br />
4) The minimum diameter of an inflated tyre shall be 400 mm.<br />
5) Tyres warmers are not allowed<br />
2.3.36 Mudguards and wheel protection<br />
Mudguards shall comply with the following requirements:<br />
1) They shall project laterally beyond the tyre on each side.<br />
2) The front mudguard shall cover at least 100° of the circumference of the<br />
wheel. In this area, the wheel may be covered, respecting the angles<br />
mentioned below. The angle formed by one line drawn from the front edge<br />
of the mudguard to the centre of the wheel and one drawn horizontally<br />
through the centre of the wheel shall be between 45° and 60°. The angle<br />
formed by one line drawn from the rear edge of the mudguard to the centre<br />
of the wheel and one drawn horizontally through the centre of the wheel<br />
shall not exceed 20°.<br />
59