Canfield Connector Buyer's Guide

5000 GEN
SERIES 5000
SOLENOID VALVE CONNECTORS
canfield connector
8510 Foxwood Court
Youngstown, Ohio 44514
(330) 758-8299 ■ Fax: (330) 758-8912
www.canfieldconnector.com
GENERAL
PRODUCT
OVERVIEW
General Description
The ISO and 8mm Sub-Micro connectors are made according to DIN 43650 / ISO 4400. The MINI and 9mm Sub-Micro
connectors are industry standards. All are used as protective enclosures for electrical connection in conjunction with
hydraulic and pneumatic solenoid valves. These connectors offer distinct advantages over “hardwired” solenoid valves
because of their modular design. Used where rapid installation and service are a must. Better than molded construction
when special wire is needed or when using one long wire run.
Dimensional Data
ALL DIMENSIONS ARE IN MILLIMETERS UNLESS OTHERWISE NOTED (COMPLETE DIMENSIONAL INFORMATION IS PROVIDED ON INDIVIDUAL PAGES)
27
40 58 44
27 27
21
1
11 PG9 21 11 21 11
2
1
2
1
2
3/8" NPTF 1/2" NPTF
MINI PG9 MINI 3/8" Conduit MINI 1/2" Conduit
40
40
40 40
26.5
26.5
26.5
26.5 23.8
1 2
26.5 18 3
PG9 26.5 18 3
PG11
1 2
26.518
3
1 2
1/2"
NPTF
26.5 18
3
1 2
1/2"
NPTF
DIN 43650 Form “A”
DIN 43650 Form “A”
DIN 43650 Form “A”
DIN 43650 Form “A”
ISO PG9 / ISO HT PG9 ISO PG11 / ISO HT PG11 ISO 1/2" Conduit ISO HT 1/2" Conduit
37 47 37 47
16 16 16
16
16 8 * 16 8 *
16 9.4 16 9.4
*Ground spade offset
by 0.2mm toward pin 1.
DIN 43650 Form “C”
*Ground spade offset
by 0.2mm toward pin 1.
DIN 43650 Form “C”
1/2" NPTF 1/2" NPTF
Sub-Micro 8mm
Strain Relief
Sub-Micro 8mm
1/2" Conduit
Sub-Micro 9mm
Strain Relief
Sub-Micro 9mm
1/2" Conduit
8