LPM/TPM III-RT - speno international sa

Software parameters permit the separation of the waves into several categories, known as bands, according to their length. Since corrugation has different effects
according to its wavelength, the tolerances are different for each band. The software allows the configuration of up to four independent bands, overlapping or not
overlapping.
Reports in the form of bar graphs represent the
divergences between the target and the measured profiles
Zone outside Zone within tolerance
Tolerance (not ground) (ground)
in order to verify if the result is in compliance with the
tolerances.
Tolerances
Averaged rectified waves
Example of a printout of the longitudi nal measurement (direct waves)
Printout of a measured and a target profile
Statistical reports : summary sheet and detailed data
Technical characteristics
On board measuring systems LPM/TPM III-RT
LPM (longitudinal meas.)
TPM (cross section meas.)
Accuracy ± 10 µm ± 100 µm
Resolution ± 1 µm ± 10 µm
Measurement range 10-3000 mm -90° to +15°
Acquisition frequency 0.002 mm (500 samples/m) 20 Hz
Max. speed 20 km/h 20 km/h
Type of measurement contact (inductive sensors LVDT) optical (laser)
SPENO INTERNATIONAL S.A. - 26, parc Château-Banquet - eng v1 2/2
P.O. 16 - 1211 Geneva 21 - Switzerland
Tel. +41 22 906 46 00 - Fax +41 22 906 46 01 - E-Mail info@speno.ch